AimSHOT HeatSeeker HS3510 Series Instruction Manual - Page 3

Browse online or download pdf Instruction Manual for Hunting Equipment AimSHOT HeatSeeker HS3510 Series. AimSHOT HeatSeeker HS3510 Series 4 pages. Infrared heat sensor with lasers

Print Page
Troubleshooting Tips:
When should I change batteries?
To ensure maximum gain, hold increase button for 30 seconds. If
the unit does not light up all 7 LEDs the battery may be weak and
should be changed.
I have just inserted batteries into my unit, but it does not turn
on.
The batteries included with the unit are covered in a protective
wrapping. Be sure to remove the wrapping, if any, from the battery
before installing.
What is the best way to detect heat using the HeatSeeker?
Be sure to scan horizontally with the HeatSeeker, not vertically.
Set the unit on maximum gain by holding the increase button for 30
seconds. Scan ground cover in a shaded area; you should see very
few signals. Then scan your HeatSeeker toward a definite heat
source, such as an animal, person, or automobile with a warm
engine. You should have no trouble receiving a strong signal.
Operating Instructions
Congratulations on purchasing the finest hand-held HEAT SEEKING SENSOR device available on the market today. The
patented HeatSeeker utilizes state-of-the art technology to ensure years of high performance and reliability. The HeatSeeker, an
intelligent and affordable choice of the informed consumer, is backed by a full five (5) year manufacturer's limited warranty! Removing
the front screws or control pad will void warranty.
1
Power Switch:
A) Push once to turn on. The unit is ready to use when the LED (7) stops flashing. The unit will automatically shut off after 20 minutes
of inactivity.
B) Push again to turn off.
2
Volume Control:
A) Plug earphone (16) into the earphone jack (11). LED (7) automatically shut off.
B) There are (7) volume level settings. Default volume level is 4.
C) Use the buttons (2) to adjust volume level.
3
Gain Control:
The gain control allows you to adjust the amount of signal the heat seeker will show the maximum reading at. The maximum gain level
is 64 and the minimum level is 0. Turn the gain down to block out weaker signals to concentrate on higher ones. Use the buttons (3) to
adjust the gain level. Press once to change in one level increments. Press and hold for more than one second to change at one level per
0.1 seconds. To insure maximum gain, hold increase button for 30 seconds. If the unit does not light up all 7 LEDs the battery may be
weak and should be replaced.
4
Laser
Switch:
A) Press once for green LED (5) to light up indicating laser is ready. Press again and the red LED (5) lights up indicating red laser is
being emitted through aperture (8). It is not necessary to use the laser but is beneficial in locating the heat source.
B) Press again to turn laser off.