Custom Dynamics ProBEAM RoadGlide PB-RG13-B Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Headlamp Custom Dynamics ProBEAM RoadGlide PB-RG13-B. Custom Dynamics ProBEAM RoadGlide PB-RG13-B 2 pages. Led

Print Page

7. Align the Rear Support Plate to the inside of the fairing

(See Figure D) to use as a template for drilling mounting

holes.

8. Drill the two 1/4" mounting holes. (See Figure E)

9. Install provided plastic clip to retainer tabs on the Front

Support Plate (See Figure F)

10. Re-align the Rear Support Plate to the inside of the fair-

ing. At the same time align the Front Mounting Plate to

the outside of the fairing.

11. Secure both the Front Mounting Plate and the Rear Sup-

port Plate with supplied mounting bolts and nuts. (See

Figure G)

12. Using a Dremel, grind down any parts of the fairing that

extrude on either side of the support plate. Both sides

must be flush with support plate to prevent the head-

lamps from hitting the fairing. (See Figure H)

13. Align 3 mounting clips on your new ProBEAM® head-

lamp to the fairing and snap the headlamp assembly into

place.

14. Bring the fairing with ProBEAM® headlamp to the bike.

Plug the H4 connectors to the new ProBEAM® head-

lamp (the red wire is for European use only).

15. Hang fairing on the 2 mounting clips located on the inner

fairing.

16. Re-install all fairing bolts.

17. Reconnect the vehicle battery negative [ - ]

18. Test all functions of both ProBEAM® Headlights to en-

sure they are working 100%

19. Adjust headlamp if needed to maximize light output.

20. Reinstall the OEM plastic headlamp cover.

Questions? Call us at: 1 (800) 382-1388

Installation Instructions - Page 2

M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST

07/2018