DK SONIC DK-1000TS User Manual - Page 2
Browse online or download pdf User Manual for Ultrasonic Jewelry Cleaner DK SONIC DK-1000TS. DK SONIC DK-1000TS 9 pages.
ULTRASONIC PRINCIPLE
PREPARATION:
Carefully unpack the cleaner, remove all packing materials and check whether any
1.
parts have become loose or damaged during transit.
Contents:
a: Main machine
d: Outlet filter
2. Place the cleaner on a flat, clean surface and ensure that the cooling fan will get
adequate ventilation, and that all controls are set to off, and the drain tap is
closed.
Ensure that the power lead is securely plugged into the cleaner, and that no part of
3.
the lead is likely to contact with moisture.
4. Carefully fill at least 7cm depth of the tank with a solvent solution. Based on
cleaning requirements, we recommend to use a small amount of cleaning solution
because this will help increase the cleaning performance. Now the cleaner is ready
for use.
Attention
While the machine is working normally, the syntony of the ultrasonic wave and tank gives
a well-proportioned sound with no shudder on the surface of the water but sprays
generated by the tiny bubbles. If there are discontinuous surges, please add or reduce a
little of washing solution in the tank to stop the surges, which is good for get a better
cleaning effect.
Ultrasonic cleaning is based on the cavitation effect caused by
high frequency ultrasonic wave vibration signal in the fluid.
Microscopic bubbles are formed, and then implode violently
causing the cavitation which create an intense scrubbing action
on the surface of the item being cleaned. The bubbles are small
enough to penetrate microscopic crevices, cleaning them
thoroughly and consistently.
Ultrasonic cleaning is extremely effective at removing dirt and
grime which would normally require tedious manual cleaning by
hand. It has been used to clean a wide variety of instruments and
mechanical parts such as carburetors, returning them to almost
"like new" condition without damage to delicate parts.
b: Sound proof lid
e: Mesh basket (Optional)
2
c: Power lead
f: Manual