Artison P-LCR/UMB Installation Manual - Page 10

Browse online or download pdf Installation Manual for Speakers Artison P-LCR/UMB. Artison P-LCR/UMB 18 pages. Speakers for video monitors and plasma panels

WIRING THE LCRS
3.1 I 5.1 Channel Set Up (Surround Sound)
1. Refer to FIGURE 9.
2. For the Left and Right Channels, connect one end of the two conductor speaker wire to the
Left Front Channel positive and negative terminals of the receiver or amplifier. Then connect
the other end of the speaker wire to the lower set positive and negative terminals located on
the rear of the speaker. Repeat this procedure for the right channel speaker wire. NOTE:
Operate the terminals by pressing on the top; this will open a hole in the side of the
terminal. Slip the bare end of the stripped wire into this hole and release the terminal.
The terminal will now securely hold the wire in place.
3. For the DualMono Center Channel, connect one end of the two conductor speaker wire to the
Center Channel positive and negative terminals on the receiver or amplifier. Connect the
supplied two meter Jumper Speaker Wire to the other end of the wire from the receiver /
amplifier by twisting the positive wires together and the negative wires together. Then insert
the twisted ends into the terminals of EITHER ONE of the DualMono Center Channels. Run
the Jumper Speaker Wire across the back of the display and connect the positive and
negative leads to the other DualMono Center Channel.
Stereo Set Up (2 Channel Operation)
1. Refer to FIGURE 10.
2. Using a single conductor of speaker wire the negative terminal of the Left Channel to the
positive terminal of the DualMono Center Channel on the same side.
Similarly wire the
positive terminal of the Right Channel to the negative terminal of the DualMono Center
Channel on the same side.
3. With two conductor speaker wire connect the Left and Right Channels of the receiver or
amplifier to the outer pair terminals of the corresponding speaker.
10