Customduo V42 Operation Manual - Page 4
Browse online or download pdf Operation Manual for Flashlight Customduo V42. Customduo V42 6 pages.
Print PageThe spot and flood LEDs can be operated separately or blended together. Each LED can be operated at v.low
(50mA), low (150mA), medium (350mA), and high (700mA), offering a choice from 24 possible light
combinations, as per following table (settings 1-4 are the four factory default levels).
(default settings
off - flood
1-4)
(0mA)
off - spot
n/a
(0mA)
v.low spot
24 lumen
(50mA)
low spot
73 lumen
(150mA)
med spot
172 lumen
(350mA)
high spot
310 lumen (2)
(700mA)
To modify a light setting, enter * followed by the number of the specific setting you wish to modify
<*(setting number 1-9)>. This will only respond to the number of light settings currently specified (as
described above). For example, if the lamp currently has 4 light settings, then only controller buttons 1-4 will
respond.
When a valid light setting is selected, use the arrow buttons on the remote to select the desired level of light
for each LED. The level of the spot LED is set using the <up> and <down> arrows, and the level of the flood
LED is set using the <left> and <right> arrows. Either of the LEDs can be set as off, but not both. When you
have selected the desired light levels of spot and flood LEDs, then enter <OK> to confirm. This procedure can
be repeated for any specified light setting.
The spot and flood LEDs can be operated separately or blended together. Each LED can be operated at v.low
(50mA), low (150mA), medium (350mA), and high (700mA), offering a choice from 24 possible light
combinations, as per following table (settings 1-4 are the four factory default levels).
While using the arrow buttons to select light level of the LEDs, you will note that the flood and spot LEDs
light up at significantly lower levels than during actual lamp operation! These levels are simply
representative of the 4 power settings of each LED, but set at lower level in order to protect your vision
when programming. However, even at these lower levels direct eye exposure should still be avoided.
3 second 'first' mode or 3 second 'last' mode
To switch between 3 second 'first' mode and 3 second 'last' mode, enter <*(0)OK>. Each time this is
performed, the v42 will toggle between 3 second 'first' mode (the spot LED will briefly light up) and 3 second
'last' mode (the flood LED will briefly light up).
Restore factory default settings
If at any point you get in a pickle, then enter <#(0)OK> to restore v42 to factory default settings.
v.low flood
low flood
(50mA)
(150mA)
24 lumen
73 lumen (1)
48 lumen
97 lumen
97 lumen
146 lumen
196 lumen
245 lumen
334 lumen
383 lumen
med flood
high flood
(350mA)
(700mA)
172 lumen (3)
310 lumen
196 lumen
334 lumen
245 lumen
383 lumen
344 lumen
482 lumen
620 lumen (4)
482 lumen