Artistry In Motion Big Shots Operation And Maintenance Manual - Page 5

Browse online or download pdf Operation And Maintenance Manual for Transmitter Artistry In Motion Big Shots. Artistry In Motion Big Shots 12 pages. Wireless transmitter and receiver
Also for Artistry In Motion Big Shots: Loading & Firing Instructions (2 pages)

Print Page

requires that the antenna be positioned on or near the ground plane, or adjacent

to metal or wire mesh, then the antenna should be replaced with our 6' antenna

extension. (Under those circumstances, please call Artistry In Motion for

technical support.) The Big Shots® Frame does not interfere with the function of

this system.

1.01 THE POWER, ARM AND CHANNEL SWITCHES.

These toggle switches are located on the topside of the enclosure. The

"POWER" switch turns on and off the battery power to the receiver electronics.

The "ARM" switch has "Safe" and "Armed" positions. In the "Safe" position, the

Big Shots ® Cannon cannot be fired. The "CHANNEL" switch allows the user to

select either "CH A" or "CH B" as the operating channel for the receiver. This

allows for two queues in the standard system.

receiver always be powered up in "Safe" mode if a device is already

connected to a cannon. The operator can then verify that the green

"BATTERY" light does not indicate that any radio reception is occurring

before arming the receiver.

1.02 THE "BATTERY" INDICATOR.

While the power switch is on, this green indicator, located on the topside of the

enclosure, will flash intermittently in bursts of one, two, or three flashes at a time

if there is sufficient 12V battery voltage input to power the receiver. If no flashing

occurs, the battery must be replaced or recharged before the receiver can be

used reliably. Three flashes per burst indicate that the battery has full capacity;

two flashes indicate that its capacity is beginning to diminish, and one flash

indicates that it is near minimum charge, in which case it should be replaced or

recharged immediately after the current use.

The green "BATTERY" indicator will light while a signal is being received that

matches the selected digital address and system firing code. This feature is

useful for warning of reception of firing signals before the arm switch is turned on.

1.03 CONNECTION TO THE BIG SHOTS® SOLENOID VALVE.

Connection to the Big Shots® solenoid valve is achieved through the three-pin

connector located at the top of the enclosure. A dust cap protects this connector.

The connector is keyed, so there is only one way to insert the plug into the

receptacle. After insertion, the locking nut on the plug should be rotated

clockwise 180 degrees to lock the plug into the receptacle.

1.04 THE POWER SOURCE.

All power is supplied from an internal 12VDC power source. The power source

used is a sealed lead acid battery. This battery should only be recharged using

the battery charger sold with this system. Using other battery charges could

result in over charging the battery that could result in destruction of the Wireless

Big Shots® Receiver.

Artistry In Motion, Inc.

Tel: 818.994.7388

Ver 08/20

19411 Londelius Street, Northridge, CA 91324

Fax: 818.994.7688

Website:www.artistryinmotion.com

It is recommended that the

Page 5