Alu-Cab EXPEDITION TENT Operating & Care Instructions - Page 2

Browse online or download pdf Operating & Care Instructions for Automobile Accessories Alu-Cab EXPEDITION TENT. Alu-Cab EXPEDITION TENT 2 pages.

Print Page

CLOSING

Retrieve ladder bag with

Step 1 :

pole bag inside.

Remove pole bag.

Step 2 :

Step 3 :

Even out bedding.

Step 9 :

Lift compression elastic to

middle of canvas.

Step 10 :

Place pull-down strap

between elastic and canvas.

To close lid, pull strap

Step 11 :

downwards. This may be done using

body weight rather than arm

strength.

Avoid closing the tent while it's still wet or damp. If this isn't possible, take the opportunity to air and dry the tent at

NOTES

the earliest opportunity.

Be careful to store the ladder against the rear of the tent before closing the lid.

Make sure the canvas is tucked on the sides when closing the tent. Failure to do so can lead to damage

If you're loading items onto the roof, make use of the accessories rails and approved roof-racks or load bars. The

load bars are designed to carry a maximum weight of 50 kg. With this added weigh it requires more strength when

opening the tent as gas lifts only assist. The roof panels themselves are not designed to carry weight and will dent if

you place items onto them.

If your tent is equipped with an electrical kit (lights & power points), make sure these are turned off and unplugged

during transit/storage.

Remove poles, top ﬁrst, then

Step 4 :

bottom.

Put poles back into bag and

Step 5 :

place inside tent.

Step 12 :

Grab handle on roof when

it comes into reach, and use it to pull

the lid closed. Make sure the canvas

is tucked in on both sides before

closing. Also, make sure at least one

window is open when closing tent or

the trapped air makes closing very

difﬁcult.

EXPEDITION TENT

Remove ladder from tent.

Step 6 :

Put ladder into bag.

Step 7 :

Step 8 :

Place ladder inside tent.

Be careful to not place ladder over

the front lip of the tent as this can

cause damage when closing the lid

of the tent.

Step 13 :

Secure lid by fastening

both catches.

page 2