Alula DWS-LL Quick Start Manual

Browse online or download pdf Quick Start Manual for Accessories Alula DWS-LL. Alula DWS-LL 2 pages. Longlife door/window sensor connect+™ encrypted
Also for Alula DWS-LL: Quick Start Manual (2 pages)

Print Page

LongLife Door/Window Sensor

ten year battery life. Typically used to sense opening and

closings of doors and windows, it will alarm when the

magnet is pulled away from the sensor.

Features

• Ten year battery life

• Quick peel and press mounting

• Secure encrypted wireless transmissions

Enroll

by placing the panel into wireless enrollment mode

and then sending an enrollment signal from the sensor.

Alternatively, the sensor can be enrolled by entering its

8-character serial number in the AlulaConnect™ portal.

Options for sending an Enrollment Signal

• Remove the battery tab, which can be done

without removing the cover, OR

• Remove the cover to trip the tamper

Note: Slide the cover to open and close

Install

by removing the adhesive paper and adhering

the sensor and magnet on a door or window. Leave a

minimum of 3/16 inch clearance around the ends of the

sensor to allow the cover to open. Make sure to align

the alignment marks on the sensor and magnet when

mounting.

High Bond Tape works great if the surface is properly

prepared and firm pressure is applied for over 10

seconds.

Surface Preparation

• Clean the surface

• Ensure the mounting surface temperature is

above 50°F

Use the panel installation guide to verify proper system setup.

LongLife Door/Window Sensor

Connect+

™

is a transmitter with a

Encrypted (DWS-LL)

Slide to

Open

3/16"