cuTex TBC-50H How To Operate - Page 5
Browse online or download pdf How To Operate for Cutter cuTex TBC-50H. cuTex TBC-50H 14 pages. Automatic ribbon tape & small webbing cutter
Print Page
- 1. How to Operate TBC-50H
- 2. Key Functions
- 3. Specification
- 4. Caution for Use
- 5. Exchange of Knife
- 6. Mount of Roll
- 7. Exchange of Fuse
- 8. Part Drawing a of TBC-50H (Feeding Part)
- 9. Part List a of TBC-50H (Feeding Part)
- 10. Part Drawing B of TBC-50H (Cutting Part)
- 11. Part List B of TBC-50H (Cutting Part)
- 12. Part Drawing C of TBC-50H (Other Parts)
- 13. Part List C of TBC-50H (Other Parts)
- 14. Trouble-Shooting of TBC-50 Series
- 15. Check Code
- 16. Error Code
③ Take off the heater after unscrewing the fixing bolt by 2.5mm-wrench.
(Install new upper knife and assemble it again vice versa.)
④ If necessary to exchange the lower knife plate, unscrew bolts of the front feeding motor.
⑤ Unscrew bolts of the front feeding roller and take off the motor & the roller.
⑥ Take off the cap by unscrewing bolts.
⑦ Unscrew 3 fixing bolts by 7mm-wrench and take off the lower knife plate.
⑧ If no cutting or one sided cutting, make the upper knife contacted to the lower knife plate
and check the level between upper knife & lower knife plate and power off & adjust gap
or pressure by 7mm-spanner. (Clockwise turn of spanner makes the lower knife plate up,
anti-clockwise turn makes it down.)
E-mail :
- 4 -
http://www.taewoocutex.com