Alula RE617 Manual

Browse online or download pdf Manual for Security System Alula RE617. Alula RE617 9 pages. Connect+ encrypted heat alarm

Print Page

RE617 Heat Alarm

device that alarms when it detects

temperatures above 135°F (57°C) or

temperature changes greater than 15°F

(8.3°C)/min and the temperature is

above 104ºF (40ºC).

Features

• UL539 and ULC-S530 listings

• Heat detection

Quick Start Guide

1. Remove the mounting plate.

2. Pull the battery tab.

3. Restore the mounting plate and

twist it fully onto the Heat Alarm.

Note: Enrollment is possible only

if the mounting plate is twisted

onto the Heat Alarm.

4. Enroll the Heat Alarm by placing the

panel into wireless enrollment mode

and then holding down the Heat's

test button until the Heat Alarm

beeps.

5. Remove the mounting plate and

refer to Sections 2 and 5 for

positioning and installation.

6. After mounting plate is installed

restore the Heat Alarm onto the

mounting plate and fully test the

Heat Alarm per Section 6.

Alternate Enrollment Methods

• Scan the Heat Alarm's bar code

using the Connect+ Installer app

• Enter the 8-character serial

number on the interactive service

provider's web portal.

To replace the battery,

Heat Alarm from its mounting plate

and replace the batteries.

This manual should be read prior to use and retained for further information.

Use the panel installation guide to verify proper system setup.

RE617 Heat Alarm

Connect+

is a fire-protection

detach the

Attention

Encrypted

™

Pull Battery Tab

12 inches

minimum

Position Heat Alarm

Test Heat Alarm

12 inches

minimum