Cutlass Fasteners Signus PHM-1A Manual - Page 6
Browse online or download pdf Manual for Welding System Cutlass Fasteners Signus PHM-1A. Cutlass Fasteners Signus PHM-1A 12 pages. Gap cd weld gun
Print Page
PHM-1A GAP CD WELD GUN MANUAL
The electrical and mechanical parameters of the weld are set using the voltage control knob on the
front of the welder and by adjusting the lift distance of the welding gun.
LEG
The welding time depends on the stud speed . It is adjusted indirectly via the lift mechanism in the gun.
The greater the lift is, the higher the speed of the welding stud as it returns to the workpiece, and hence
the shorter the welding time.
The lift is set with the rear cap on the back of the weld gun:
Turning the rear cap clockwise will increase the
lift, thereby reducing the weld time.
Turning the rear cap counterclockwise will reduce
the lift, thereby increasing the weld time.
To prevent damage to the adjusting mechanism,
never use force to turn the rear cap at the limits of
the adjustment.
COPYRIGHT CFI 2009
Cutlass Fasteners, Inc.
83 Vermont Ave., Unit 6, Warwick, RI 02888
Tel: (401) 732-6333 Fax: (401) 732-6336
cutlass-studwelding.com
WELD GUN SETUP
1/8"
The weld chuck should be adjusted as shown. For longer
studs, as much of the stud should be held as possible.
This may require complete removal of the adjusting screw.
1/16 -1/8"
Seat weld chuck firmly in the front of weld gun and attach
WELD
leg and footpiece assembly. Set leg depth so
STUD
approximately 1/8" of stud/chuck protrudes beyond the
footpiece.
FOOTPIECE
ADJUSTING THE PHM-1A WELD GUN
email:
Stud Welding...
Fasteners
Equipment
Service
PAGE
6
-
-