DKS 8057 Installation And Programming Manual - Page 2

Browse online or download pdf Installation And Programming Manual for Receiver DKS 8057. DKS 8057 3 pages.

Print Page
MASTER CODE
1.
Press the master code button
2.
Enter a four-digit master code on the keypad, then press
FACILITY CODES
1.
Press
2.
Press
(beep) for the first facility code. Be sure to increment this number each time
another facility code is entered. Use 0 for facility code 10.
3.
Enter the two-digit facility code, then press
4.
Repeat steps 2 and 3 to enter additional facility codes.
5.
Press
together to end the programming session (beeeeeep).
BUTTON NUMBER
1.
Press
2.
Enter the button number that the receiver is to respond to (1-2-3), then press
3.
Press
together to end the programming session (beeeeeep).
RELAY STRIKE TIME
1.
Press
2.
Enter a two-digit number (00-99) for relay activation in seconds, then press
entering 00 programs the relay for ½ second.
3.
Press
together to end the programming (beeeeeep).
PROGRAM TRANSMITTER CODES
1.
Press
2.
Enter the five-digit transmitter code, then press
3.
Repeat step 2 to enter additional transmitter codes.
4.
Press
together to end the programming (beeeeeep).
PROGRAM TRANSMITTER GROUP
1.
Press
2.
Enter the five-digit code for the lowest number transmitter in the group, then press
3.
Enter the five-digit code for the highest number transmitter in the group, then press
4.
Press
together to end the programming (beeeeeep).
DELETE TRANSMITTER CODES
1.
Press
2.
Enter the five-digit transmitter code to be deleted, then press
3.
Repeat step 2 to delete additional transmitter codes.
4.
Press
together to end the programming (beeeeeep).
DELETE ALL TRANMITTER CODES
1.
Press
2.
Enter 9999, then press * (beep).
3.
After approximately 25 seconds, a long tone (beeeeeep) will be heard to ending the
programming sequence.
NOTE 1: This step applies to receivers with Rev E (2/01) circuit boards or higher. Earlier revisions require the
receiver case to be opened to access the master code switch. All other programming steps remain the same.
P/N 8057-065 REV A 2/01
1
on the side of the receiver.
and the four-digit master code (beep).
and the four-digit master code (beep).
and the four-digit master code (beep).
and the four-digit master code (beep).
and the four-digit master code (beep).
and the four-digit master code (beep).
and the four-digit master code (beep).
(beep).
(beep).
(beep).
(beep).
(beep).
(beep). Note:
(beep).
(beep).