DKS 1520 series Installation And Owner's Manual - Page 13
Browse online or download pdf Installation And Owner's Manual for IP Access Controllers DKS 1520 series. DKS 1520 series 16 pages. Stand alone card readers or controller
Also for DKS 1520 series: Manual (2 pages)
Print Page
2.7 Timed Anti-Pass Back
The 1520 has a timed anti-pass back feature that will prevent a card code from being used within a period on time from the last
use of the card code. To use the anti-pass back feature, you must set the time and date (section 2.3), set the pass back time (1
to 59 minutes) and turn the anti-pass back feature ON. Factory default is OFF.
2.7.1 Anti-Pass Back ON/OFF
Factory setting for this feature is OFF (0).
1. Press
2 5 and enter the MASTER CODE. [
*
2. Enter 0 to turn ant-pass back OFF or enter 1 to turn ant-pass back ON, then press
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.7.2 Anti-Pass Back Time
1. Press
2 6 and enter the MASTER CODE. [
*
2. Enter two-digit anti-pass back time in minutes (01 – 59), then press
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.8 Clear Transaction Memory
CAUTION: This programming sequence will clear the transaction memory buffer. This cannot be UNDONE.
1. Press
3 6 and enter the MASTER CODE. [
*
2. Enter 9 9 9 9, then press
3. A long beep after approximately 5 seconds indicates that the transaction memory buffer is cleared.
Note: Transaction buffer stores up to 3656 events.
2.9 Real-Time Print Mode
These programming steps allow you to turn the real time print feature of the 1520 ON or OFF. When turned ON, the printer will
print the transaction as it occurs and store it in the transaction buffer. When turned OFF, the transaction is stored in the transac-
tion buffer for printing at a later time. See Section 1.4 1520 Wiring for printer connection.
Factory default is OFF.
1. Press
3 5 and enter the MASTER CODE. [
*
2. Enter 0 to turn real time print OFF or enter 1 to turn real time print ON, then press
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.10 Card Reader Test Mode
The test mode allows you to determine if a card reader or other wiegand device connected to the 1520 is functioning or not.
When the 1520 is in the test mode, any card presented to the reader will have its facility code and card number printed.
1. Press
2 3 and enter the MASTER CODE. [
*
2. The controller is now in test mode.
3. Press 0 # TOGETHER to end the test mode and return to normal operation. [0 # (beeeeeep)]
1520-065-E-7-16
2 5 _ _ _ _ (beep)]
*
2 6 _ _ _ _ (beep)]
*
3 6 _ _ _ _ (beep)]
*
. [ 9 9 9 9
(beep)]
*
*
3 5 _ _ _ _ (beep)]
*
2 3 _ _ _ _ (beep)]
*
. [ _
(beep)]
*
*
. [ _ _
(beep)]
*
*
. [ _
(beep)]
*
*
11