ALUZ A8-ZIZA-STN Manual - Page 10
Browse online or download pdf Manual for Lighting Equipment ALUZ A8-ZIZA-STN. ALUZ A8-ZIZA-STN 12 pages. Led tape
Print Page
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting channels.
2
Lay extrusions along reference line and drill at least 3 countersink holes per
extrusion. Drill additional holes as needed.
3
Screw extrusions to surface using countersink screws.
Note: Ensure extrusions are aligned. Misalignment will prevent lens from
snapping in.
Extrusions aligned
4
After all extrusions have been securely mounted, remove adhesive backing
from lightstrip and adhere in place along extrusion channel, ensuring
lightstrip is secure inside extrusion.
Note: Refer to Application Guidelines to ensure correct installation.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | LED Tape
ZIZA Standard
(A8-ZIZA-STN)
Countersink hole
Countersink screw
Install lightstrip into extrusions
Remove adhesive backing
866.ALUZ.LTG | 714.535.7900
5
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
6
Install lens into extrusion, overlapping where two extrusions meet. Plan
your cuts so that the lens will always overlap where two extrusions meet.
Overlapping lenses helps keep extrusions aligned and prevents light leaks.
test before connecting luminaire to power source.
Two extrusions meet
7
Perform a continuity test before connecting luminaire to power source.
Page 10 of 12
Mounting Fixture (Wet Location
Unassembled Mounting Channel)
Lens overlapping
Installation Instructions
4 / 11 / 2022 / Rev 1