ALUZ ZIZA Manual - Page 11
Browse online or download pdf Manual for Lighting Equipment ALUZ ZIZA. ALUZ ZIZA 14 pages. Led tape
Print Page1
Measure area where luminaire will be installed. Use a laser line to
create a reference line along installation area, ensuring consistent
alignment of mounting channels. Mark location where each
channel will be installed along reference line.
2
Lay mounting channels along reference line and drill at least 3
countersink holes per channel. Drill additional holes as needed.
3
Screw mounting channels to surface using countersink screws.
Note: Ensure channels are aligned.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | LED Tape
ZIZA Tape
(A8-ZIZA-TAPE)
866.ALUZ.LTG | 714.535.7900
4
After all mounting channels have been securely installed, install
tubes into channels, overlapping where two channels meet.
Overlapping tubes help keep channels aligned.
5
Ensure tubes are secured in place.
6
If applicable, connect disconnects between luminaires or solder
connectors using the steps on Application Guidelines.
7
Perform a continuity test before connecting to power source.
Refer to Continuity Test for details.
Page 11 of 13
Mounting Lightstrip
(Wet Location Mounting Channel
for Lightstrip in Square Tube)
Installation Instructions
8 / 11 / 2023 / Rev 2