DLP S200 Quick Manual

Browse online or download pdf Quick Manual for Projector DLP S200. DLP S200 2 pages.

Print Page
LOCATION OF PARTS AND CONTROLS
2
AOME
Projector
S200
QUICK GUIDE
AUDIO
USB
9
10
LOCATION OF PARTS AND CONTROLS
1:
Lens
2:
Air outlet
3:
Up
1
1
4:
Confirm
Return(
)
press more than 2 seconds
5:
Right
6:
Left
7:
Down
8:
Power indicator
3
9:
Audio output(
)
3.5mm
4
10: USB input/Power out
5
6
11: HDMI input
7
12: DC input (15V/1.5A)
8
R
HDMI
15V
11
12
7
REMOTE CONTROL
The 2.4G wireless remote control must be paired with projector before using.
Within 2 minutes after power on, press and hold the Vol+ and Vol- around 3
1:
Power
seconds，then the indicator light in the remote will be flashing quickly, when the
2:
Speaker
quick flashing stopped, it will pair successfully.
3:
Air inlet
2
4:
Tripod dock
5:
Rating Label
6:
Non-slip mat
7:
Focus wheel
3
8:
Speaker
4
5
6
8
FCC Statement
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
Indicator
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
Power off
Home
harmful interference to radio or television reception, which can be determined by
Confirm
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Direction Key
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
Mouse
receiver is connected.
Return
Menu
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Volume
Radiation Exposure Statement
This device complies with RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
AAA Battery
IC Note:
This device complies with Industry Canada's licence-exempt RSSs. Operation is
subject to thefollowing two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada . Son
fonctionnement est soumis aux deux conditions suivantes :
(1) Ce dispositif ne peut causer d'interférences ; et
(2) Ce dispositif doit accepter toute interférence , y compris les interférences
qui peuvent causer un mauvais fonctionnement de l'appareil.