Alvarado Supervisor 500 Installation Instructions Manual - Page 8
Browse online or download pdf Installation Instructions Manual for Turnstiles Alvarado Supervisor 500. Alvarado Supervisor 500 19 pages. Barrier-free optical counting turnstile
Print Page
Portable Baseplate Assembly (Optional)
An optional SU500 portable baseplate may be purchased with the SU500 turnstile. A baseplate enables installation of the SU500
turnstile on a solid foundation without the need to drill holes in the ground. The portable baseplate also provides concealed conduit
channels for wiring all power and communication cables. Baseplates come in different sizes and may be bridged together with
other baseplates for multiple turnstile lanes. The following information will guide the installer in assembling the portable baseplate:
Figure 12
Portable Baseplate
Conduit holes for power and communication cables.
(Use separate conduits for power and communication
cables)
Holes for bridging multiple
baseplates
Examine the area with a measuring tape and carefully mark the location where the portable baseplate(s) will be placed. Primary
power and Ethernet cables (if applicable) must be accessible and provided to the turnstile. The side plate on the portable baseplate
must be removed in order to route power / Ethernet (or the side plate may be drilled with appropriate holes as needed for
concealment). Determine which side plate to remove and remove it by unfastening the (4) screws as shown in [Figure 12].
Place the portable baseplate carefully in the marked location. The installation process continues in the following sections. Follow
the instructions there in order to pull the appropriate cables through the conduit openings.
For multiple lanes, baseplates may be attached together. Holes are provided for bridging multiple baseplates together. The side
plate must be removed in order to bridge the baseplates together side by side. Secure the baseplates side by side by fastening the
(6) screws provided to the link from the other baseplate (a link is provided for multiple lane baseplates).
Page 14
For Assistance: [email protected] +1 (909) 591-8431
SU500 Installation Instructions
SU500 Installation Instructions
Anchor Locations
Side Plate
Side Plate
Screws
PUD1456R5-0
PUD1R5-0
Installation Instructions
Anchoring the Turnstile
NOTE
The Lane 1 master cabinet is always the right-most cabinet when viewed from the entry side of the turnstile.
1.
Place the master cabinet and the slave cabinet in the determined location [see dimensions - Figures 3 -4].
2.
Cabinets must be level to each other and square to all neighboring cabinets. This will ensure that all optical sensors are aligned
for optimum performance. Use the following procedure to square each cabinet with respect to the floor and other cabinets:
A.
Measure the distance from the inside wall of one
cabinet to the inside wall of the other cabinet, on both the
entry and exit side of the lane for a consistent measurement
[Figure 13].
B.
Measure the diagonal distance from the end of one cabinet
to the end of the opposing cabinet, then measure the
opposing diagonal [Figure 14]. If these distances are equal,
the cabinets are square.
For Assistance: [email protected] +1 (909) 591-8431
Figure 13
Figure 14
Page 15