AKO H 260/1 Technical Data - Page 2

Browse online or download pdf Technical Data for Heater AKO H 260/1. AKO H 260/1 2 pages.

Print Page

4. Electrical Connection

The voltage information of the type plate must match the

present mains voltage.

Do not operate the heating device via an external switching

unit, e.g. via a clock timer. In addition, the heating device

must not be connected with a current circuit which is

switched on and off regularly. This may result in an

unwanted reset of the overheating protection (see also

Chapter 6).

If a wall socket must be installed or the connecting lead

needs to be replaced, this may only be done by skilled

electricians according to the applicable regulations.

5. Heating Operation

All models

The desired room temperature is set by turning the

thermostat knob clockwise. Heating operation is indicated

by an indicator lamp.

The lowest position on the thermostat is frost protection .

In this setting, the thermostat switches the heating on at an

ambient temperature of approx. 5 °C.

Clock timer - model H 261/1

Turn the timer knob in a clockwise direction. Set the desired

time period (up to 60 minutes).

During the set time, the unit operates at the nominal output

of 2,000 W. The thermostat is not operational.

The set operating time can be interrupted or shortened at

any time by turning the timer knob in the counter-clockwise

direction.

Upon expiration of the set time period, the unit will

automatically switch to a heating output of 1,000 W. The

thermostat controls the set room temperature.

Glen Dimplex Deutschland GmbH

Am Goldenen Feld 18

95326 Kulmbach, Germany

www.glendimplex.de

Thermostat

Indicator lamp

Timer

Model H 261/1

Phone +49 (0)9221 709564

Telefax +49 (0)9221 709589

E-mail: [email protected]

When the set time period has expired, a frost protection

function is activated. If the room temperature drops below

approx. 5 °C, the unit will switch on automatically with a

heating output of 1,000 W.

6. Protection against Overheating

For safety reasons, the heater is equipped with an

overtemperature protection feature. If the unit exceeds the

permissible temperature, it will be switched off

automatically. Disconnect the unit from the power supply in

such cases for several minutes. Pull the mains plug and let

the heating device cool down.

The unit can be restarted after rectifying the fault (e.g.

blocked or covered air screen).

7. Faults

In the event of faults, please contact your electrical retailer.

If required, you can also address your queries to the service

hotline of Glen Dimplex Germany GmbH.

Tel.: +49 (0) 9221 709-564

Fax: +49 (0) 9221 709 589

To process your order, please state the device type as well

as its production number (E No.) and manufacturing date

(FD).

This information is listed on the type plate.

Repairs and corrective measures may only be carried out

by skilled electricians or your after-sales service.

8. Cleaning the Device

Switch off the device and let it cool down before cleaning it.

Keep the air inlet opening (rear of unit) and the air outlet

opening (front of unit) free of dust. Remove dust from the

exterior of the unit using a vacuum cleaner.

Clean the outside of the unit using a soft, damp cloth and

dry it off. Do not use scouring powder or furniture polish as

this may damage the surface.

9. Warranty

This product is supplied with a two-year warranty according

to our terms of guarantee.

10. Note on Disposal

Do not dispose of the unit with general household

waste. The device must be taken to a local waste

disposal plant.

Subject to technical changes

09/06/A