DLS AMPD1000E Owner's Manual - Page 7
Browse online or download pdf Owner's Manual for Car Amplifier DLS AMPD1000E. DLS AMPD1000E 8 pages. Digital class ”d” mono amplifier for subwoofer use 1000 watts output power into 1 ohm load
Print PageCONNECTION DIAGRAM D 1000
7. Connection diagram D 1000
This amplifier is constructed for use as a subwoofer amplifier. All features on the amplifier is made for this
purpose. It is possible to connect speakers in many various ways as long as the impedance load is not
lower than 1 ohm. The speaker terminals on the amplifier are internally connected in parallel.
D 1000 can be connected in some of these ways:
Subwoofers with single 4 ohm voice coil:
1. With one subwoofer connected to one of the terminals.
2. With two subwoofers, one to each terminal.
3. With three subwoofers, two to one terminal and one to the other terminal.
4. With four subwoofers, two in parallel to each terminal.
Subwoofers with dual 4 ohm voice coil:
1. One subwoofer with the separate voice coils connected one to each terminal.
2. Two subwoofers with the voice coils connected in parallel on each subwoofer and then connected with
one subwoofer to each terminal.
There are a number of more ways to connect if you have more than four subwoofers as long as the
impedance load to the amplifier is not lower than 1 ohm.
Four 4 ohm subwoofers
connected in parallel.
The speaker impedance is 4 ohms in this
example giving an amplifier load of 1 ohm.
For filter setting see page 4.
POWER INPUT
+12V REM GND
Fuse
80 A
+
Battery
12 volt
SPEAKERS
+ SP -
- SP +
REMOTE
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
OVERLOAD
+
+
-
-
+
+
-
-
Remote
- 6 -
PROTECT
LEVEL
BASS BOOST LOWPASS
Min
Max
0 dB 18 dB
35 Hz 250 Hz
Sub level
remote control
1 101,9
FM
LINE INPUT
POWER
SUB SONIC
L
R
15 Hz 35 Hz
L
R
LINE OUT
Pre
out