DLS Performance series How To Install And Operate - Page 9
Browse online or download pdf How To Install And Operate for Car Amplifier DLS Performance series. DLS Performance series 16 pages. Reference series car audio speakers
Also for DLS Performance series: Owner's Manual (12 pages), Owner's Manual (4 pages), Owner's Manual (4 pages)
Print Page
Speaker wiring CA 31
Two fullrange
speakers to
channel A/B
With the HPF-filter in OFF
position the amplifier allows
the speakers to play
fullrange. If you for some
reason want to limit the low
bass reproduction switch on
the HPF-filter. The typical
setting is then around 60 –
80 Hz.
HPF
90Hz
120Hz
Off On
50Hz 150Hz
One (or two)
4 ohm
+
subwoofers
to channel C
Filter settings channel C
The subsonic filter takes away the very deepest
frequencies. Turn on the subsonic filter if you want
to remove these frequencis.
The LPF will allow low frequencies only and blocks
higher frequencies. A typical setting is 70 – 100 Hz.
The phase control can be set continuously from 0 -
180 degrees. This is very useful when you want to
adjust the bass sound for best front stage image.
Start on 0 and turn the control slowly clockwise until
you experience the bass sound coming from the
front. If you dont get the result you want, also try to
phase reverse the subwoofer connections and make
a new adjustment.
CA31
+ C CH -
-
9