DLX ASAP Quick Manual - Page 2

Browse online or download pdf Quick Manual for Paintball equipment DLX ASAP. DLX ASAP 2 pages.

Print Page

GENERAL SETUP

Cut patch 1 inch beyond all edges of the tear. If using more than one patch, overlap at least

1 inch. Trim and round corners.

Peel back 1/2 inch of paper liner.

Position exposed edge - allowing the patch to extend 1 inch beyond all edges of the tear. Peel

back the liner while applying the patch over tear. Follow steps 1-3 on the back side of the repair if

you have access to the backside.

Repairing tears extending through and outside edge

Follow steps 1-3 with the following adjustments:

- Cut the patch size to extend a full 1 inch beyond the edge of the torn material

- Peel and stick, positioning the patch with a 1 inch tab beyond the outside edge of the torn material

Turn the material over so that the adhesive side of the tab is facing up.

Position reinforcement filament tightly against the outside edge. The filament should be

perpendicular to the open end of the tear to create a tough solid edge.

Fold over the patch's 1 inch tab and rub to adhere to the backside of the material.

Apply another patch to the backside of the patched tear (so that both sides of material are

patched). Rub the entire patch aggressively.

NOTE: HEATING IS AN OPTION AND NORMALLY NOT NEEDED UNLESS TEMPERATURES ARE BELOW FREEZING.

Fold 1 inch Tab Over Filament

ASAP

REPAIR

Tear on Edge

Apply Leaving 1 inch Tab Beyond Edge

P ROUDLY MA DE I N THE US A. / / CA GE C OD E : 7 C FK 2 / / D UN S # : 0 7 9 7 5 1 0 6 4 / / S B A 8 ( A ) C E RTI FI E D / / © 2 0 2 1 D L X EN TER PR I SES L L C

Apply Reinforcement Filament

Apply to Back Side

Cut Filament to Width of Patch