3M Multimedia Projector S15 Product Safety Manual - Page 9

Browse online or download pdf Product Safety Manual for Projector 3M Multimedia Projector S15. 3M Multimedia Projector S15 13 pages. Multimedia projector
Also for 3M Multimedia Projector S15: Brochure & Specs (4 pages), Specifications (2 pages), Product Safety Manual (15 pages), Specification Sheet (2 pages), Quick Start Manual (4 pages), Quick Start Manual (4 pages)

Print Page

For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.

Also, do not install an old or previously used lamp.

1. Remove lamp access door: Please loosen the screw (marked by arrow) (1). Then, unhook the

claws of the lamp door (2), and remove the lamp door (3).

2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (4)

All lamp module screws must be loosened. These screws are self-containing screws that

cannot be removed from the lamp module or access door.

3. Remove lamp module: Slowly pick up the lamp module by the handles. (5)

4. Insert lamp module: Carefully insert (5) the new lamp module. Ensure that it is fully seated.

Tighten the lamp module retaining screws (4) to secure the lamp module in place.

Optional Lamp: 78-6969-9812-5 (Contact 3M customer Service.)

Insert the hinge tabs on the bottom of the lamp access door (6), then

two claws (7) to ﬁx the lamp door.

Reset the lamp operation hours. See "Reset Lamp Hours" for details.

(1) Screw marked

by arrow

(2) Claws

(3) Lamp access door

√ Note

(4) Screws marked

by arrow

(5) Handles

3M™ Digital Projector S15/X15 Product Safety Guide

push the center point of

(6) Tab

(7) Center point of

claws