Blue Angel BCPA10 Quick Start Instructions - Page 5

Browse online or download pdf Quick Start Instructions for Measuring Instruments Blue Angel BCPA10. Blue Angel BCPA10 13 pages. Advanced text notification

Print Page
Operating Instructions and Parts Manual
Figure 5
d. Once the status light turns solid
green this device is ready to
receive text messages from your
cell phone. (Figure 6) In the next
step, you will program the device
by sending it text message
commands from your cell phone.
Solid
green
light
Figure 6
STEP 7 - ENTER EMERGENCY
Advanced Text
Notification
a. Using your cell phone, create and
send a text message to the
Advanced Text Notification
number that you saved in step 5.
Type the following command:
Phone1{space}10 digit phone
number. (Figure 7)
b. It is recommended to add contact
numbers for Phone1, Phone2 and
Phone3. In case of an emergency
alert, if one of the phone numbers
are out of network range, service
has been interrupted or
disconnected, or the phone is off,
it will NOT receive an alert text
notification. The device will send
alerts to all of the phone numbers
that have been saved to Phone1,
Phone2 and Phone3 entries.
The reference to "{space}"
throughout this manual
indicates a space in the text entered
e.g. Phone1 5557654321 and should not be
entered as shown with brackets and the
word "{space}", otherwise the entry will be
invalid and you may not be able to send and
receive text alerts.
This number will be saved to
Phone1 or position #1. It is
necessary to type the set up as
shown in the diagram including
spaces where indicated.
Otherwise, set up may not be
successful.
NOTE: Do NOT enter a "1"
in front of the area code.
The Professional's Line
PUSH TO TEST
CONTACTS
Adding emergency contacts
Phone1{space}<10 digit phone number>
Figure 7
c. If successful, the device will chirp
twice and you will receive a
text message to the phone
number you just entered in
approximately 30 seconds after
the device chirps. (Figure 8) You
can repeat this process up to two
additional phones, using Phone2
and Phone3 commands. See
troubleshooting section if this step
is unsuccessful. (Page 9)
Unit settings
Advanced Text Notification:
Name: My Advanced Text
#1 5557654321
#2
Figure 8
#3
Contractor:
Congratulations!
Contact:
Your installation is complete.

STEP 8 -TEST DEVICE

Press the "PUSH TO TEST" button to
test the system. (Figure 9)
Figure 9
FLOAT TEST: Lift each float
individually. Confirm that the unit
responds with an audible alarm and
a corresponding text message. When
floats are returned to home position,
an "OK" test message should be
received.
POWER TEST: Unplug A/C power
(for 10 seconds). Confirm that alert
text message is received. Restore
power and an "OK" text message
should be received.
NOTE: Text messages may take
up to (1) minute to receive and is
based upon signal strength and
cellular network congestion. If text
message is not received, refer to
troubleshooting section. (Page 9)
www.blueangelpumps.com/AdvancedText
5
BCPA1
EXAMPLE CELL PHONE SCREEN:
Phone1 5557654321
EXAMPLE CELL PHONE SCREEN:
EXAMPLE CELL PHONE SCREEN:
John Doe Residence
is operating correctly
at 8:55AM on __/__/__