dobar 50131 Instruction Manual - Page 5
Browse online or download pdf Instruction Manual for Pet Care Product dobar 50131. dobar 50131 8 pages. Large-capacity automatic pet feeder
Print PageQuick Start Guide
50131 Large-capacity Automatic Pet Feeder
Introduction
Be familiar with the product before using it for the first time.
Please read the following operating instructions and the safety
instructions carefully. Use the product only as described and for the
specified application areas. Keep these instructions. Hand over all
documents when passing the product on to third parties.
Intended Use
This product is only suitable for the feeding of pets for private use.
The product is not intended for commercial use.
General safety instructions
Damages caused by non-observance of these operating instructions
will void the guarantee claim! No liability is assumed for conse-
quential damages! No liability is accepted for damage to property
or personal injury caused by improper handling or neglecting the
safety instructions!
Control Panel Keys
•
CLOCK – displays clock (current time)
•
TIMER – switches between preset feeding times
•
VOL – sets the feeding volume/portion-size
•
SET – enters SET mode, confirms any feeding times you enter
and advances to the next setting. Also used with VOL key to
perform manual feedings
•
START – starts the feeding schedule, confirms clock and
feeding-time settings
•
DAY – sets the number of days to feed
REC – records your personal voice message
•
PLAY – plays back your personal voice message
•
ON SWITCH – turns the feeder off. For when the feeder will
•
not be used for an extended period of time. Turning this switch
off WILL RESET all time and feeding settings
Control Panel
Getting Started
1. Open the battery door (under the unit)
2. Insert four D-size alkaline batteries into the battery tray. Do
NOT use old or -cheap- carbon batteries
3. Close the battery door and switch on the feeder. The ON
Switch is next to the battery door (under the unit)
4. The feeder will cycle once until (12:00) is flashing on the LCD
display
5. You now have 90 seconds to set the current-time in order for
the feeder to work properly. If longer than 90 seconds passes
then (1 07) will be displayed on the LCD. Simply turn the switch
to OFF, wait 1 minute, then repeat from step-3
Setting the Current Time
1. All digits should now be flashing
2. Press the CLOCK key to set HOUR
3. Press the TIMER key to set MINUTE
4. Press the SET key once to confirm time
The display will show either 12 or 24 to indicate the display
mode
5. Press the CLOCK key to change between 12- or 24-hour display
mode
6. Press the START key to CONFIRM clock setup
7. (1 07) will be flashing and you must now set the feeding times
Setting the Feed Time and Number of Feedings per Day
1. (1 07) should now be flashing. Digit-1 is the feeding number
(times per day), Digits-3 & 4 are the feeding time (in hours)
2. The display shows the 1st feeding time (1 07)=(1st feeding at
7 am)
3. With (1 07) Flashing, Press and HOLD (for 2 seconds) the SET
key until Digit-3 & 4 start flashing (07)
4. Press the TIMER key to set the desired hour for feeding. Note
the (P) in the top left corner stands for PM when using 12 hour
time
5. Press the SET key to confirm your setting and proceed to the
2nd feeding time
6. Repeat step-4 to set the desired hour for feeding the SECOND
Digit-1 Digit-2 Digit-3 Digit-4
feeding time
7. At this point if you want to only feed 2 times per day press the
START key and you're finished
PM
8. If you wish to feed a 3rd or 4th time each day do NOT press the
START key and repeat from step-4
icon
Tip: If you pressed the SET key a 3rd time, but you did not want to feed 3
times per day, just press the TIMER key then press and hold the SET key (for
2 seconds) to start over, remember not press the SET key after the Second
feeding, press the START key to end your number of feedings per day.
Setting the Volume/Portion-Size
1. Press the VOL key to display feed-volume/portion-size
2. Press and hold (for 2 seconds) the SET key until Digit-4 blinks
3. Press the VOL key to set the desired volume
Note: a) A Feed-volume of 1 equals ¼ cup (60cc) of food, 2 means ½ cup
(120cc) of food, 3= ¾ cups (180cc) and so on.
b) The number 0 represents 10 portions which is equal to 2.5 cups (liters).
4. Press the START key to confirm the volume/portion size
LCD Display
T
C