ET Water HermitCrab 2 User's Installation Manual - Page 10

Browse online or download pdf User's Installation Manual for Controller ET Water HermitCrab 2. ET Water HermitCrab 2 12 pages.

ET Water HermitCrab 2 User's Installation Manual
Toro® TMC-212®
PREPARING YOUR TMC-212 CONTROLLER:
The TMC-212 has preset schedules tht need to be
removed
before you can connect it to the HermitCrab.
1. Turn the control dial to" WATERING DAYS"
2. Select Program A using the programs switch
3. Press the -/OFF button until the display reads "OFF"
4. Repeat the above steps for Program B and Program C
5. After all three programs have been cleared turn the
control
dial to "RUN"
6. Power the controller off before you connect the
HermitCrab.
ATTACHING THE HERMITCRAB COMMUNICATIONS
CABLE:
1. Remove the lower housing cover
2. Connect each individual fly wire to each 24 VAC termi-
nal. The fly wires can be connected to either terminal.
3. Connect the RJ11 into the communication port.
Toro® TMC-424®
PREPARING YOUR TMC-424 CONTROLLER:
1.Set the controller to the "OFF" position.
2. Power off the controller before you connect the
HermiCrab®
communications cable.
ATTACHING THE HERMITCRAB COMMUNICATIONS
CABLE:
1. Open up the control panel door.
2. Connect each individual fly wire to each 24 VAC
terminal. The fly wires can be connected to either terminal.
3. Connect the RJ11 into the communication port.
Page 16
RJ11 cable
Each Fly wire
connected to the
connected to the
communications
"24 VAC" terminals
port
Each Fly wire
RJ11 cable
connected to the
connected to the
"24 VAC" terminals
communications
port
Weathermatic® SmartLine + Proline
Models
PREPARING YOUR WEATHERMATIC
CONTROLLER:
1. Set the Weathermatic to "SYSTEM OFF."
2. Power off the controller.
ATTACHING THE HERMITCRAB
COMMUNICATIONS CABLE:
1. Plug the HermitCrab controller communications cable
into the remote connector.
Superior® Sterling
PREPARING YOUR STERLING HOST MC-E 2011 CON-
TROLLER:
1. Set the Sterling controller to the off position.
2. Power off the controller
ATTACHING THE HERMITCRAB
COMMUNICATIONS CABLE:
1. Connect the HermitCrab controller communications cable
to the connector labeled REMOTE on the bottom right of
the panel.
Connect
communications
cable to either port
Connect
communications
cable to port
HermitCrab communications cable
attached to Sterling remote connector
Page 17