Docking Drawer 0290-00045(W) Manual - Page 4

Browse online or download pdf Manual for Indoor Furnishing Docking Drawer 0290-00045(W). Docking Drawer 0290-00045(W) 6 pages.

Print Page

Removing the Receptacle Box–

For a successful Docking Drawer Slim USB charging outlet installation, it is NOT necessary to remove the

receptacle box from the cable management arms. However, if the receptacle box needs to be removed,

please follow these steps to disconnect/reconnect the receptacle box from the cable management arms.

1. Remove the cable arm ground connection

inside the receptacle box by removing the

green ground screw and ring terminal as

shown. DO NOT remove the ground wire

that goes to the receptacle.

2. Remove the blue wire nut connecting the

black wire from the cable chain to the black

wire going to the circuit breaker.

3. Use a Phillips head screwdriver to remove the

(2) #10 screws from inside the receptacle box.

This will allow the cable arm bracket to be

disconnected from the receptacle box.

DO NOT REMOVE

4. M ount the power cord bracket in the correct

location on the back wall behind the drawer

as shown in the drawing.

5. Install the drawer in the cabinet, and hold on

to the end of the arm assembly.

6. Pass the wires from the cable management

arms into the receptacle box and reattach

the bracket using the screwdriver and

(2) #10 screws.

7. Secure the receptacle box to the back of the

drawer using the installer supplied hardware.

8. R econnect the black wire from the circuit

breaker to the black wire from the cable

management arm using the blue wire nut.

9. DO NOT FORGET TO REATTACH THE

GROUND WIRE INSIDE THE RECEPTACLE

BOX. TORQUE SCREW TO 16-18 IN-LBS.

ENSURE THAT THE CIRCUIT BREAKER IS

WIRED IN SERIES WITH THE LINE (BLACK)

WIRE. SEE WIRE DIAGRAM.

MAKE SURE BOTH GROUND SCREWS

ARE SECURELY CONNECTED!

TORQUE TO 16-18 IN-LBS