fleetfinder GOLD User Manual - Page 9
Browse online or download pdf User Manual for GPS fleetfinder GOLD. fleetfinder GOLD 19 pages.
Print Page9.5 COMMAND LIST
Fleetfinder GOLD
Command
PIN XXXX
Pin number security, for the access
of the Fleetminder, Also used for
setting the primary identity. And
firmware upgrade password.
NEWPIN
Used to change the pin number
from the default setting
PH2 XX
Sets the secondary number for
event reporting.
INPUTS
To set input parameters
LABELIN N X (admin only)
Renames the label heading for
an input
QUERYINLABEL N
Queries the Label settings for the
Inputs.
DELAYIN N T
To set a delay timer on an input
trigger.
GPISMS N X (SMS Only)
To enable SMS alerting for a defined
input.
OUTPUTS
To set/enable the outputs
SETGPO N L
Sets the outputs N for Latch
Purpose
Default setting
PIN 0000 (Used to set the
primary identity and firmware
upgrade password.)
No default
No default
No default
No default
No default
No default
Options
PIN XXXX (used to change the
PIN 1234 will check the pin number
primary identity, as long as the PIN
in the unit, and if void, will ignore
number is correct)
the message, but if correct, it will
change the primary identity to the
phone number where the message
was sent from.
NEWPIN XXXX where XXXX is the
NEWPIN 1234 will change the pin
new 4 digit pin number
number from the unit, as long as the
message is sent from the primary
identity.
PH2 XX where XX is the second-
PH2 0412345678 will set the sec-
ary phone number, note. PH2
ondary number to 0412345678
without the number, will disable
this feature.
Up to 16 characters for all 3 inputs.
LABELIN 1 Starter will set the label
LABELIN N X where N is the
of input 1 to "Starter"
number of the input (1-3), and X is
the name for the input
QUERYINLABEL N where N is the
QUERYINLABEL 1 will request the
input number (input 1 to 3)
LABEL heading for Input 1
Used to set a delay for input trig-
DELAYIN 2 20 will set the input 2
gering, where N is the number of
delay time for 20 seconds, before
the input (1 -3) only, and T is the
sending an alert,
delay time in seconds.
This feature is used to enable or
GPISMS 2 ON will enable sms alert-
disable SMS alerting for a particular
ing for Input 2.
input.
SETGPO 1 L - Will set output 1
SETGPO 1 L - Will set output 1
for Latch
for Latch
P14
Example
SMS Response.
(Queried Via SMS).
CFG:PIN XXXX (where XXXX is the
pin number for the device)
CFG:NEWPIN XX(where XX is the
new pin number)
CFG:PH2 XX (where x is the sec-
ondary number)
CFG:LABELIN N X (where n is the
input number and x is the input
name)
CFG:QUERYINLABEL N X (where
n is the number of the input, and x
is the label that is ser for the input
queried)
CFG:DELAYIN N T (where N is the
input number, and T is the Time in
seconds)
CFG:GPISMS N X (where N is the
number of the input and X is the
status of the input(ON or OFF))
CFG:SETGPO N L (where N is the
number of the input and L is the
Latch setting)