AKOS NV-150H-F1 Installation Manual - Page 12

Browse online or download pdf Installation Manual for Indoor Fireplace AKOS NV-150H-F1. AKOS NV-150H-F1 20 pages. Insert fireplace

Print Page

Placing the appliance

− Take the installation requirements into account (see chapter3)

− Place the appliance into the proper position and if necessary, adjust the height with the

adjustable legs.

− Adjusting the height and leveling the hearth with a spirit level.(see fig. 1.5)

− Always place the appliance with a minimum distance of 1000[mm] from combustible materials or

objects.

− Place the discharge pipes in such a way that situations with a risk of fire can never occur.

− Always place the appliance in front of a wall of non-combustible and heat-resistant material.

− Always maintain a minimum distance between appliance and a back wall.

− Take sufficient measure to prevent temperature of a wall behind the chimney breast becoming

too high, including the materials and/or objects behind it.

− Do not cover the appliance or wrap it in an insulation blanket of any other material.

− Make sure that the appliance is installed in a stable position.

− In case of a wall or roof terminal, the hole must be at least 5 mm bigger than the diameter of the

flue material.

− Horizontal parts must be installed at a (3 degree) slope up away the appliance.

− Build up the system from the appliance. If this is not possible, you should make use of a

adjustable pipe.

− For fitting the system a ½ metre cut-down pipe should be used. Make sure the inner pipe is

always 2 cm longer than the outer pipe. Wall and roof terminal are also shortened. These parts

must be secured with self-tapping screws.

− Do not insulate but ventilate build-in flue material (approx.100cm2)

− Before constructing the false chimney breast we advise you to perform a function test with the

gas hearth as described in chapter 7 "checking the installation"

− Construct false chimney to comply with the installation requirements.

− Construct the false chimney breast from non- combustible sheet metal in combination with metal

profiles or of brickwork / aerated concrete bricks.

− Take the grates and the service panel (see fig. 1.1 and1.2 )into account. Place a protective shield

made of non- combustible material above the grates (see fig.1.1A) .

− Always use a lintel if the chimney breast is constructed of brickwork. These should not be placed

directly onto the appliance.

− Construct the chimney breast against the build-in frame (see fig. 1.1B).

− Keep a minimum margin of 3 mm between chimney breast and the appliance in connection with

the expansion of the appliance.

− The depth of the recess has no influence on the removal of the glass.

AKOS Sp. z o o.

ul. Bruszewska 22, 03-046 Warszawa

NIP: 5361925006; REGON 365653140

Tel: +48881697975; email: [email protected]

12 <