AKOS NV150H-F2-L Installation Manual - Page 14

Browse online or download pdf Installation Manual for Indoor Fireplace AKOS NV150H-F2-L. AKOS NV150H-F2-L 20 pages. Insert fireplace

Print Page

− It is not allowed to add different or more materials to the combustion chamber. Always keep the

pilot burner free from decorative material!

−

DO NOT BLOCK THE PILOT FLAME HOLE

HOLE by placing decorative material on the pilot flame hole, do not block the pilot flame hole by

placing imitation embers on the pilot flame hole, do not block the pilot flame hole by placing

decorative logs on the pilot flame hole, DO NOT BLOCK THE PILOT FLAME HOLE by placing

pebbles on the pilot flame hole, do not block the pilot flame hole by placing anything on the pilot

flame hole – the pilot is located lower than the burner, thus blocking the pilot flame will result in

failure to ignite the gas in the fire place, therefore under any condition

THE PILOT FLAME HOLE!!!

− Do not toss all the decorative material onto the burner all at once; instead place it accurately

upon the burner, in order to prevent obstruction of burner by dust particles.

− Placing of decorative material should be done by the qualified, skilled, experienced, trained

professionals only.

− Place the decorative material according to the attached decorative material placement manual.

Imitation logs

a. Place a number of the Vermiculate charcoals onto the burner and on the cover plate

b. Place the imitation logs according to the following instructions: it is possible to place the

logs as user's decision, follow the main limitations, do not place the logs on each other by

more than one cross. In case of placing decorative logs by more than one cross, soot

could be covering the logs. Do not place any log on top of the pilot burner, make sure

there is no any block between the pilot flame and burner gas outlet.

c. Divide the remainder of the Vermiculate charcoals over the burner and the cover plate.

Avoid a thick layer onto the burner, this has a negative effect on the fire image.

d. Ignite the pilot and main burner according to the instructions in the user's manual.

e. Assess whether the flame division is correct. If necessary, move the chips until there is a

proper division of flames.

Place the glass and check the fire image.

a. Place the pebbles on the burner and the cover plate (see fig. 3.3 or imitation logs instruction

card supplied). Avoid a double layer; this has a negative effect on the fire image.

b. Place the glass and check the fire image.

AKOS Sp. z o o.

ul. Bruszewska 22, 03-046 Warszawa

NIP: 5361925006; REGON 365653140

Tel: +48881697975; email: [email protected]

, DO NOT BLOCK THE PILOT FLAME

DO NOT BLOCK

14 <