DOD FX75C Quick Manual

Browse online or download pdf Quick Manual for Music Pedal DOD FX75C. DOD FX75C 2 pages.

Print Page
DOD FX75C Quick Manual
FLANGER
STEREO
What the FX75C Stereo Flanger Does
The FX75C splits your guitar signal, adds a short
delay to one of the signals, and then changes the
delay time at an even rate.This results in a slight
fluctuation in pitch of the delayed signal The FX75C
then adds a "whooshing up, and down" sound to
your guitar by incorporating regeneration into the
delayed signal.
Connecting The FX75C
Connect your guitar to the input of the FX75C.
Connect the output of the FX75C to the input of
your amplifier (or to the input of another effect
device you may be running). For stereo sound, con-
nect the Stereo output to the input of a second
amplifier..To eliminate the need for a 9 volt battery,
connect the PS200R to the AC power jack on the
FX75C
China
in
Printed
75C
FX
18-1075-A#01
FX75C
notice.
without
change
to
subject
are
manual
this
in
Corp.
Electronics
DOD
1999
568-7638
(801)
Fax
International
568-7642
(801)
Phone
566-7005
(801)
566-8800
(801)
Telephone
84070
UT
Sandy,
Parkway
Sandy
S.
Corporation
Electronics
Features
• LED indicator shows status of effect and battery.
• Stereo effect generation from mono input.
• Active switching for noiseless operation.
• Easy access battery compartment.
• Adapter jack for AC operation.
• Rugged die-cast metal chassis.
• Three year limited warranty.
• Rubber non-skid bottom.
Controls
Level - This knob adjusts the overall volume level of
the Flange Effect.
Speed - This knob adjusts the rate of the modulat-
ing delay time.
Depth - This knob adjusts the intensity of the mod-
ulation
Regen - This knob sets the amount of regeneration
which is perceived as the up and down
motion.
Footswitch - Bypasses, and re-engages the effect
LED Indicator - Lights when the Flange is active and
is not lit when the effect is
bypassed.
Jacks - Input, Output, AC adapter (use only the
PS200R).
or
Office
Service
specifications
The
Copyright
89/336/EEC
Directive
EMC
Low
the
of
requirements
International
Fax
3
2,
1,
amendments
8760
Specifications:
DOD
equivalent).
or
EN60742,
of
requirements
the
to
adapter
power
II
Class
USA
84070,
Parkway
Sandy
Corporation
Electronics
Conformity
Operation of the FX75C
The FX75C was designed to give you the thickness
and animation typical of the classic Flange effect.The
following sample settings are starting points for you
to begin making your own flange effect sounds.
Settings for a tremolo sound:
Settings for a thick flange:
Slow sweep for a "tubular" pipe sound:
Computer Voice (weird sound):
568-7642
(801)
Fax:
to
due
568-7638
(801)
Tel:
USA
84070,
Utah
Sandy,
or
damages
Parkway
Sandy
S,
8760
or
DOD
Office
Sales
International
connec-
and
Sales
DOD
local
Your
Contact:
European
any
authorizes
1999
29,
December
expressed
USA
84070,
Utah
Sandy,
Parkway
Sandy
S.
8760
Engineering
of
President
Vice
products
Corporation
Electronics
DOD
with-
product
93/68/EEC.
Directive
by
amended
as
or
design
the
and
72/23/EEC
Directive
Voltage
the
with
complies
herewith
product
The
Information:
Supplementary
of
burden
(1991)
55020
EN
(1990)
55013
EN
EMC:
in
use
product's
with
(1985)
IEC65
for
liable
(1993)
60065
EN
Safety:
a
to
Product
following
the
to
Conforms
original
EN60065,
of
conforms
that
repairing
a
All(Requires
Options:
Product
FX75C
Name:
Product
workmanship
product:
the
that
declares
the
within
Utah
Sandy,
S.
8760
Address:
Manufacturer's
DOD
Name:
Manufacturer's
ten
within
of
Declaration
Important Notes
• The FX75C battery is in use whenever you are
plugged into the INPUT jack.To extend the life of
the battery, be sure to disconnect the input when
the FX75C is not in use.
• Remove the battery when the FX75C will not be
used for an extended period of time.This will pre-
vent possible damage due to leaking battery fluids.
• Battery replacement is indicated when the FX75C
fails to switch in and out, or when the LED stays
lit.
• Keeping the battery in the FX75C while using an
AC adapter will provide continuous operation in
the event of a power failure.
• Use of any power adapter other than the PS200R
will void the warranty of this product.
• No user serviceable parts inside. Removal of the
bottom plate will void the warranty of this prod-
uct. Should your FX75C require servicing, contact
your authorized DOD dealer for return/repair
information.
control.
their
beyond
causes
warranty
this
of
performance
the
in
delay
any
from
consequential
or
special
for
liable
be
dealers
its
shall
event
no
In
product.
this
of
sale
the
with
tion
in
liability
or
obligation
any
it
for
assume
to
person
nor
assumes
neither
DOD
and
implied,
or
warranties,
other
all
of
lieu
in
is
foregoing
6.The
manufactured.
previously
on
same
the
install
to
obligation
any
incurring
out
this
upon
improvements
or
to
additions
make
in
changes
make
to
right
the
reserves
DOD
5.
consumer.
the
the
be
to
considered
is
date
Proof-of-purchase
4.
assembly.
or
circuit
any
the
of
result
a
as
damage
consequential
any
be
not
shall
company
years.The
three
of
period
up
covered
be
will
labor
and
parts
all
where
dealer,
the
through
returned
is
product
the
provided
defect,
evidence
show
that
materials
defective
replacing
or
to
limited
is
warranty
this
under
liability
DOD
3.
service.
and
use
normal
under
and
materials
in
defects
from
free
be
to
U.S.,
solely
used
when
product
this
warrants
DOD
2.
warranty.
this
validate
to
date
purchase
of
days
mailed
be
must
card
registration
warranty
1.The
Warranty