DOD Acoustic1 Owner's Manual - Page 12
Browse online or download pdf Owner's Manual for Amplifier DOD Acoustic1. DOD Acoustic1 18 pages. Guitar preamp/fx processor
Print Page
Storing Programs
User
Store
DATA
User
Store
Bypassing
10
signal processing
NOTE: When you change the selected Parameter from the stored
value, a decimal point appears in the bottom right corner of the
display and the Store LED lights.
That's it! You can manipulate any effect setting in the Acoustic One by
pressing the associated Effect button on the front panel and turning
the Data wheel. The Effect Group buttons toggle the effects on and off
with each successive press of the button.
When you're editing Programs, be sure to pay attention to the flashing
Status LEDs. This helps you keep track of where you are in the menus.
IMPORTANT: If you want to store your custom Program so you
can use it later, follow the procedure below.
The Acoustic One helps you remember whether or not you've stored
the Program you're working on by lighting the Store LED under the
bottom right corner of the display when the selected Program has
been edited.
Remember that if you change any settings in a Program, you have to
store the Program into a User memory location. Otherwise, all your
changes will be lost.
To store a Program into a memory location:
1) Press the Store button. The Store LED begins flashing and the
User LED lights (if not lit already).
2) Use the Data wheel to select the User location where you want
to store the Program.
3) Press the Store button again to store the Program in the loca-
tion you selected.
After the storing procedure is complete, the Acoustic One returns to
normal operation at the new Program location.
NOTE: Factory Programs can't be overwritten. When you modify a
Factory Program and store it in memory, the Program is stored in
the corresponding number location in the User Program section.
The Acoustic One's bypass functions are very simple.
To bypass individual effects:
1) From Program mode, decide which effect you want to bypass
and press the Select button twice. The display reads:
For all effects:
Press the effect Select button to toggle the effect in and out of bypass.
-- .
For EQs:
Acoustic One owner's manual
0º