Etac N10200 User Manual - Page 8
Browse online or download pdf User Manual for Lifting Systems Etac N10200. Etac N10200 19 pages.
Print Page
Molift Smart 150 | BM09299 Rev C | www.etac.com
Charge the battery. The battery must not be in
the battery holder on the lifting column during
assembly or folding.
Assembly
Remove the transport elastic band.
Engange the break on the rear castors by step-
ping on the left pedal set. Open the legs.
Lift up the lifting column and slide it down into
the bracket on the chassis. Make sure it is placed
completely in the bottom of chassis.
The column must be fixed with the locking handle
on the back of the chassis. Pull the sling bar out
of the transport hook
Be careful not to get legs/arms/hands
caught between the parts when rais-
ing/folding down the lifting column.
Assembly
Battery and Hand control
1. Connect hand control to bottom of battery
holder.
2. Insert battery with terminals facing down.
3. Pull out elastic band and guide hand control
through. Pull some of the cable through so
the hand control does not fall to the floor
when dropped.
Folding (Transport mode)
Run the lifting arm all the way down, and remove
battery. Fold the hoist in reverse order of assem-
bly. Fix the sling bar back into the hook.
It is possible to split the hoist into two separate
parts by lifting the column from the chassis
completely.
Checklist after assembly
Do not use the product until you
have checked all points in the
checklist below
Use this checklist to verify that the hoist is properly
installed and can operate correctly and safely
before use.
Ensure that the lifting arm, lifting column and
sling bar are properly fixed and that there are
no loose parts on the hoist.
Make sure battery is charged (no lights on the
battery indicator).
Check that the hoist has no apparent damage
or other faults.
Perform a lift with load (approximately 50 kg)
8