ETAGTRON PG-308 User Manual - Page 6

Browse online or download pdf User Manual for Accessories ETAGTRON PG-308. ETAGTRON PG-308 18 pages.

3.5 EAS system is composed of three parts

EAS Sensor,EAS Deactivator and EAS Electronic Label and Tag. There are two kinds of electronic labels and tag:

soft label and hard tag, the cost of soft label is lower, we can paste it on the "hard" commodities directly, one soft

label just can be used for one time. The cost of hard tag is higher than the cost of soft label, but the hard tag can be

reused for many times. The hard tag must work match with detacher, it is usually used on soft commodities which

is easy to be penetrated. The deactivator is non-contact devices, it have a 15cm deactivation height. The

deactivator will kill the soft label when the cashier put the soft label close but without contacting to the deactivator.

There is also the deactivator and laser barcode scanner composing device, it can finish the barcode scanning and

label deactivate at the same time, which is much more convenient for the cashier. If using this kind of composing

device, we need pay much attention on the interferences between the deactivator and the laser barcode scanner,

then we just can get a good deactivation height. If there are customers take the commodities without deactivation

through the eas system, the system will alarm, then store staff will know and come to handle situation.

4. Installation instructions and Tuning manual

EB-R6100 is a multi-loop single panel system that provides enhanced detection when compared to a

conventional single panel system. In this Manual, you will find the important field measurable parameters to verify

proper system operation.

4.1 Antenna Wire Colors:

Pl insure the different loops are connected to the correct terminal blocks, otherwise the system couldn't work.. The

upper loop connect to ANT2 and the under loop connect to ANT1. The AC(18V) power supply is connected to

AC_IN or AC_OUT, one power supply at most can power two