DOEPFER Dark link Owner's Manual - Page 15

Browse online or download pdf Owner's Manual for Recording Equipment DOEPFER Dark link. DOEPFER Dark link 20 pages. Usb/midi-to-cv/gate interface
Also for DOEPFER Dark link: Owner's Manual (20 pages)

Print Page

DOEPFER

To reset the device, depress and hold the learn button while the power supply is plugged in. The LED will

light up and you have to keep the button depressed for a few seconds until the LED starts flashing. Pres-

sing the button again gets you back into normal operation mode and the LED will turn on.

After resetting, Dark Link's parameters are set to the following default values:

- MIDI channel 1

- Reference note 36 (i.e. the lowest „C" on a standard 5-octave keyboard)

- Retrigger: on

- CV3: volume (controller #7)

- CV4: modulation (controller #1)

- Key assign mode: highest note

- Internal Arp-Tempo: approx. 120 BPM

- Gate length: 6

- Octave: 1

- Arppeggiator Sync: internal

These values are identical with the factory default settings.

3.7. Firmware Update

Dark Link's firmware can easily be updated via USB. In case a new firmware version is available, you can

download it from our website (www.doepfer.de). A detailed description of the update process can be found

in the additional technical description of Dark Link. You can download this documentation here:

www.doepfer.de -> Products -> Dark Link -> Additional technical documentation

3.8 Changing gate signal and CV2 range by setting internal jumpers (ser-no. 112700 and

higher)

• Dark Link can generate gate signals of 5V or 12V as well as switch triggers. You can select the desired

trigger signal by simply setting the internal jumper JP1 on Dark Links circuitboard.

• The MIDI pitchbend related control voltage CV2 can have two different ranges: -2,5V to +2,5V or 0V

to +5V. Please select the desired voltage range by setting the internal jumpers JP2A / JP2B on Dark

Links circuitboard.

How to set the jumpers JP1 and JP2A / JP2B:

• Pull off Dark Links power plug and open the box carefully with a fitting scewdriver.

• Localise jumper JP1 and jumpers JP2A / JP2B on the circuitboard (see page 16).

• Set the jumper into the desired position. Avoid touching other parts and soldering side of the

circuitboard.

• Close the box again.

Dark link

Functions