Cyfral CC-4000 Operating, Installation And Programming Manual - Page 2
Browse online or download pdf Operating, Installation And Programming Manual for Intercom System Cyfral CC-4000. Cyfral CC-4000 8 pages. Control electronic
Print Page
1.
introduction ................................................................................................................................................................................ 2
2.
Device description ..................................................................................................................................................................... 3
3.
Installation methods ................................................................................................................................................................... 4
4.
Connection ................................................................................................................................................................................ 4
5.
Acoustic channel........................................................................................................................................................................ 5
6.
Connection of uniphonesand video distributors ......................................................................................................................... 6
7.
Serial number ............................................................................................................................................................................ 6
8.
View of board ............................................................................................................................................................................. 8
9.
Technical data of the device: ..................................................................................................................................................... 8
1.
INTRODUCTION
Before installing the device, read the following operating instructions. Installation may only be carried out by a
qualified person with the adequate qualifications.
This manual applies only to the CC-4000 control electronics which is part of the CC4000 system. The description of
programming and connecting with the rest of the system elements can be found in the CC4000 System Manual.
CC-4000 control electronics and devices connected to it are only allowed to be supplied with very low voltage (ELV)
with a value not exceeding the acceptable safe touch voltage. Power devices (12V DC power supplies) must
comply with EMC and safety standards in accordance with applicable European Union standards and ensure full
galvanic isolation from the power grid.
The device is equipped with a 2.5 A fine fuse It is forbidden to connect foreign installations and devices to the
terminals of the CC-4000 board, as this may result in unforeseen operation of the device, fire or electric shock.
The device is intended for installation in a plastic housing inside rooms or flush-mounted housing of the PC-4000
panel. It is not allowed to install the CC-4000 control electronics on the building façade or fence posts.
Terminal marking on the CC-4000 board:
POWER SUPPLY:
+12V
Positive power supply
GND
Supply minus
C
ONTENTS
~2~