1010 Music Bitbox User Manual - Page 6

Browse online or download pdf User Manual for Synthesizer 1010 Music Bitbox. 1010 Music Bitbox 11 pages.
Also for 1010 Music Bitbox: Quick Start Manual (2 pages)

Print Page

More Clip Information

To see additional parameters from the

screen

button or press the INFO button. You will then see the

More Clip Info

On the

More Clip Info

parameters by turning the Control Knob closest to the parameter on the

screen:

Loop Mode

Pitch

Quant Size

Slice Size

P. 5

v. 1.0

Clip Info

screen shown on the right.

screen you can adjust each of the four

With Loop Mode ON, playback will continue to repeat the portion of the sample

specified by the

Start

This parameter adjusts the tone and the playback speed of the sample--unless you are

using slicing. It is expressed in semitones and ranges from -24 semitones (down two

octaves) to +24 semitones (up two octaves).

This parameter enables you to quantize when the playback starts and stops. It has the

following values available:

None - always start and stop immediately

●

1/16 - quantize to the next sixteenth note time

●

1/8 - eighth note

●

1/4 - quarter note

●

1/2 - half note

●

1 bar - a whole note assuming 4/4 time

●

2 bars

●

4 bars

●

8 bars

●

Example: With the quant time set to 1 bar, samples will start and stop when the next bar

or measure begins. You can see the current bar and beat in the upper left of most

screens.

When this parameter is enabled, bitbox will subdivide the sample into pieces that will

play in sync with the clock. The available values are the same units as the

Size

. For drum samples, small values like 1/8 or 1/16 work best. For drones or pads,

larger numbers like 1 bar may sound best. This parameter is only valid when

Size

is something besides

screen, touch the on-

and

Length

parameters on the

None

Bitbox User Manual

Clip Info

screen.

Quant