Dogtra BALL TRAINER Owner's Manual - Page 9

Browse online or download pdf Owner's Manual for Pet Care Product Dogtra BALL TRAINER. Dogtra BALL TRAINER 11 pages. Dual-function launcher / dropper

Print Page

13. Code Setting

The transmitter has a code for each button. In order to add another receiver,

you will need to code the new receiver to the transmitter.

1) Make sure that the receiver is off.

2) Press and hold down the on/off button on top of the receiver for 5 seconds.

3) The LED indicator light will rapidly blink green. You can release your finger

from the button.

4) Press the number on the transmitter that you would like to code the

receiver to. You may check that it is properly coded by pressing the button

on the transmitter, which will activate the LED indicator light on the receiver

at the same time.

* You can code up to eight receivers to one transmitter

Warning!

Do not use any other transmitter before programming a new receiver. The

receiver can accidentally code to another transmitter if used at the same

time. If this happens, you will need to recode the receiver to the correct

transmitter.

Follow the instructions below to attach the included belt clip to the transmitter.

1. Align the belt clip to the grooves on the back of the transmitter.

2. With a firm grip, screw on the belt clip's Phillips head screws with

a screwdriver.

Caution!

Tighten until firmly in place. Be careful not to over tighten.