cymatic audio Live Player LP-16 Product Manual - Page 17
Browse online or download pdf Product Manual for Media Player cymatic audio Live Player LP-16. cymatic audio Live Player LP-16 19 pages.
Print Page16.2.6. Settings View: About Tab
Revision
Displays the revision number of the control panel itself.
Live Player LP-16
Displays the connection-status for the LP-16, indicating if the device is connected and recognized
by the computer.
Serial Number
Displays the specific serial number of the connected LP-16 unit.
Driver Version
Displays the version number of the installed device driver
Firmware Version
Displays the current firmware version of the connected LP-16 unit.
PRODUCT MANUAL
32
16.3. Using the LP-16 as an Audio Interface with OS X
16.3.1. Minimum System Requirements
!
16.3.2. Driver Installation
16.4. Using the LP-16 as an Audio Interface with an Apple® iPad®
16.4.1. Minimum System requirements
16.4.2. Driver Installation
17.
USB INTERFACE MODE
UPDATING THE FIRMWARE ON YOUR LP-16
Operating Systems:
•
Mac OS X® 10.8
Hardware:
•
Any Mac hardware compatible with OS X 10.7 or higher
•
512 MB Ram (1GB or more recommended)
•
1 free USB 2.0 compatible port
NOTE: The speed of your processor, amount of RAM, and capacity, size, and speed of your hard
drives will greatly affect the overall performance of your recording system.
A faster processor and more RAM can reduce signal latency (delay) and improve overall
performance.
There is no driver installation for OS X Computers necessary. Simply connect the LP-16 to your
Mac® by connecting the supplied USB cable to the LP-16 USB2.0 connector on the rear panel,
and an available USB2.0 port on your Mac.
The device will now be selectable in the "Audio MIDI Setup" application, which can be found in
the Applications/Utilities folder.
Note that no custom LP-16 mixer control panel is available for the Mac, as there is when using
the LP-16 with Windows. The internal DSP mixer of the LP-16 is not available when connected to
a Mac, so all monitoring must be done through the DAW software.
Operating Systems:
•
iOS® 5 or higher
Hardware:
•
iPad® 2 or newer
•
Apple® iPad Camera Connection Kit
•
Apple Lightning to USB Camera Adapter
There is no driver installation for the iPad® necessary. Simply connect the LP-16 to your iPad®
by connecting the supplied USB cable to the LP-16 USB2.0 connector on the rear panel and the
iPad® using the appropriate Apple USB adapter.
The LP-16 can now be used as a 2-input, 18-output audio interface with the iPad® and appropriate
iOS recording software.
UPDATING THE FIRMWARE ON YOUR LP-16
Please check the Cymatic Audio website (www.cymaticaudio.com) for any available firmware
updates.
The LP-16's currently installed firmware version is shown briefly on the start screen when the unit
is powering up and can also be found in the PC Mixer Panels 'About' tab
If you find that your firmware version number is lower than the latest firmware released on
the website, please download and install the newer firmware, following the instructions that
accompany the firmware download file.
PRODUCT MANUAL
33