Clopay EZ-SET Assembly/Installation Instructions - Page 10

Browse online or download pdf Assembly/Installation Instructions for Garage Door Opener Clopay EZ-SET. Clopay EZ-SET 12 pages. Torsion spring system

Print Page

Step 9:

Install the tube retainer as shown in Figure 15.

Attach the tube retainer to the EZ-SET

Spring System bracket with a

riage bolt. be sure to position the carriage bolt

and flange nut as shown in Figure 15. Be sure to

install a tube retainer on both the left and right

sides of the door.

NOTE: Tube retainer may be periodically

lubricated with a light household oil if

squeaking occurs.

To avoid personal injury, do not rest hand

or any other part of your body on the spring

or any part of the EZ-SET

System while tensioning or untensioning the

spring.

during winding, operate the drill at hAlf

SPEEd until the required number of winds

is reached. If additional winding is required

or the system has to be completely unwound,

wait AT lEAST fIVE mINUTES between

consecutive winds/unwinds. If for any reason

the unit begins to resist winding STOP winding

at once and wait AT lEAST fIVE mINUTES

before continuing. failure to follow these

instructions may result in damage to the

unit, the rapid release of spring energy, or

personal injury.

To remove All tension from the spring,

unwind (drill in reverse/counterclockwise) until

the spring paint stripe is a single

straight line and the lift cables are slack.

Only adjust the number of spring winds when

the door is completely closed.

Torsion

" - 16 x

" car-

Torsion Spring

Bracket

Carriage

Bolt and

flange Nut

fig. 15

Tube

Retainer

lEfT SIdE ShOWN