Acquaer SEC050T-1 Owner's Manual - Page 4

Browse online or download pdf Owner's Manual for Water Pump Acquaer SEC050T-1. Acquaer SEC050T-1 15 pages. Submersible sewage pump

Print Page

This unit is designed only for use on 115 volts (single phase), 60 Hz, and is equipped with an approved

14.

3-conductor cord and 3-prong grounded plug. DO NOT REMOVE THE GROUND PIN UNDER ANY

CIRCUMSTANCES. The 3-prong plug must be directly inserted into a properly installed and grounded

3-prong, grounding-type receptacle. Do not use this pump with a 2-prong wall outlet. Replace the

2-prong outlet with a properly grounded 3-prong receptacle (a GFCI outlet) installed in accordance with

the National Electrical Code and local codes and ordinances. All wiring should be performed by a

qualified electrician.

Protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the cord.

15.

Do not use damaged or worn cords.

WARNING: Always use handle to lift pump. Never use power cord to lift pump. To avoid skin

burns, unplug and allow time for the pump to cool after periods of extended use.

Estimated Assembly Time (New installation): 30 minutes (or longer if installing new sump pit).

Materials Required for Assembly (not included):

Threadsealanttape, 2 in. Check valve, 2 in. Elbow, 2 in.Union, 2 in. Nipplepipe, 2 in. Gate valve

Tools Required for Assembly (not included):

Wrench, Phillips screwdriver

Connecting a discharge pipe to the pump

Wrap the threads of the 2 in. discharge pipe (1) with threadsealant tape.

Attach the discharge pipe (1) to the discharge of the pump(2).

Placing the pump in a basin

Place the pump on a hard surface inside a sewage basin.

ADDITIONAL SAFETY PRECAUTIONS

PREPARATION

INSTALLATION INSTRUCTIONS