CYP CH-1527TXV Operation Manual - Page 8

Browse online or download pdf Operation Manual for Transmitter CYP CH-1527TXV. CYP CH-1527TXV 20 pages. 4k uhd+ hdmi over hdbaset transmitter (pse) & receiver (pd)

Print Page

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter's Front Panel

STD/HQ: This switch allows user to select which compression mode

to use when AVLC is active. HQ (High Quality) mode uses the

least amount of compression and provides the highest possible

visual quality (perceptually identical to the original). STD (Standard

Quality) mode applies additional signal reduction methods to

lower the bandwidth requirements of 4K sources further, improving

transmission reliability over longer cable runs at the cost of some

visual fidelity.

ISP: This button is reserved for factory use only.

STD/UPDATE: This switch is reserved for factory use only. The default

setting is "STD".

RS-232 IN: Connect to a PC, laptop or other serial control device

for the extension of RS-232 signals.

LAN: Connect to an Ethernet supporting device or to your local

network, as appropriate, to extend the network to both ends of

the HDBaseT connection.

SYNC LED: This LED will illuminate when a live input source is

detected.

HQ/STD LED: This LED will illuminate whenever the AVLC function

is active. A green LED indicates that AVLC is in HQ (High Quality)

mode. A red LED indicates that AVLC is in STD (Standard) mode.

POWER LED: This LED will illuminate to indicate the unit is on and

receiving power.

LINK LED: This LED will illuminate solidly when a live connection with

a compatible Receiver is active. The LED will blink with a regular

pattern if a Receiver is connected but there is not currently a live

signal. The LED will blink with an irregular pattern if a connection

error has occurred.

UPDATE

STD

1 2

HQ/STD