CYP 5Play HDBaseT PU-507-TX Operation Manual - Page 8
Browse online or download pdf Operation Manual for Receiver CYP 5Play HDBaseT PU-507-TX. CYP 5Play HDBaseT PU-507-TX 16 pages. Hdmi over single cat5e/6/7 hdbaset - bi-directional poc receiver (full 5play & single lan up to 100m)
Print Page
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Receiver Front and Rear Panels
Front
HDMI Out
1
2
1
HDMI Out: Connect to a HDMI equipped TV/monitor for display of the
HDMI input source signal.
2
LAN: Connect to a PC or Laptop to the Internet or network
connection.
3
RS-232 Out: Connect to the device that is to be controlled (via D-Sub
9 pin female cable) by RS-232 commands.
4
Power LED: This blue LED will illuminate when the device is
connected to a power supply.
5
DC 24V: Plug the 24 V DC power supply into the unit and connect
the adaptor to an AC outlet. Only one side of power needs to be
connected to activate both transmitter and receiver.
6
IR 2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the
equipment to be controlled.
7
IR 1 Extender: Connect to the supplied IR receiver cables for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR extender.
8
Link LED: The yellow LED will illuminate when both the input and
output signals are connected.
9
CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6
cable for transmission of all data signals.
8
Receiver
RS-232 Out
3
Rear
IR2 Blaster
Power
DC 24V
IR1 Extender
4
5
6
7
8
9