1010music Toolbox User Manual - Page 12

Browse online or download pdf User Manual for Recording Equipment 1010music Toolbox. 1010music Toolbox 16 pages.
Also for 1010music Toolbox: Quick Start Manual (2 pages)

Print Page

Beat Sync

Controls the

operation of the rate

parameter.

Press HOME or touch the grid in the top left corner to return to the Main Screen.

Note:

If a value of an LFO parameter is changed during playback of the sequence, the change will take

•

effect immediately

Use the Control Voltage Sequencer

Toolbox can generate one control voltage sequencer (SEQ) signal. This signal plays out the Control Voltage

Output Jack 8. The output range for this signal is 0V to +5V. To configure the SEQ:

From the Main screen, touch the SEQ button in the lower right corner to display the CV Sequencer screen.

Press the INFO button to display the CV Sequencer Parameters screen.

Use the control knobs to adjust the values of the parameters:

Parameter

Description

Step Len

The length of each step

in the sequence

Quant Size

Defines precisely when

to restart the sequence

when using the internal

clock. When the

sequence ends, toolbox

will wait until the start of

the next Quant Size

interval to restart the

sequence.

Step Count

The number of steps in

the sequence. The

number of step bars on

the screen will remain

the same, but if a value

lower than 32 is

selected, the sequencer

will only move through

the number of steps

selected.

Clk Source

This parameter allows

you to use an alternative

input as the clock signal.

By default, the toolbox

internal clock (INT) will

be used.

Touch the INFO button again to return to the CV Sequencer Screen.

On the CV Sequencer screen, use touch gestures and control knobs to configure the values of the

sequencer steps. When the sequence is playing the cursor will move across the step bars to show the

current playback position. Touch a step bar to set the value at the height selected. Turn the left control

P. 12

11/23/17 10:32 AM

On, Off

Range of Values

1/64, 1/32T, 1/32, 1/16T, 1/16, 1/8T,

1/8, 1/4T, ¼, 1/2T, ½, 1 bar, 2 bars, 4

bars, 8 bars

(T= Triplet)

1/64, 1/32T, 1/32, 1/16T, 1/16, 1/8T,

1/8, 1/4T, ¼, 1/2T, ½, 1 bar, 2 bars

(T= Triplet)

1 to 32

INT, EXT1, EXT2, EXT3, GATE1,

GATE2, GATE3, GATE4

Digital Heart – Analog Soul

Toolbox User Manual

Figure 1 4: C V Sequencer

P arameters Sc reen

Figure 1 5: CV Sequencer

Screen