Ashly SRA-2075 Operating Manual - Page 6

Browse online or download pdf Operating Manual for Amplifier Ashly SRA-2075. Ashly SRA-2075 12 pages. Sra series standard power amplifiers
Also for Ashly SRA-2075: Operating Manual (12 pages), Brochure & Specs (4 pages), Specification Sheet (2 pages), Specification Sheet (2 pages)

Print Page

Page - 6

Important Safety

Instructions – 2

Installation

Introduction - 3

SRA-Series amplifiers are designed for use in both fixed and mobile sound systems. Each

The SRA Series - 4

amplifier is shipped (unless otherwise specified) with the following factory settings:

Physical Description - 5

Front Panel

Front panel:

Rear Panel

On/Off Switch = Off

Installation – 6

Attenuators = ∞

Requirements

Installation Density

Typical Applications

Connectors & Polarity

Before connecting to mains power, make sure that the switches are set to the configuration

needed for your particular application. Always switch the amplifier off before making any

Operation - 8

changes to the settings. Failure to do so could result in damage to the unit or other components

Troubleshooting - 9

in your system. CAUTION: When mounting or connecting the amplifier, always disconnect it

Spec Table - 10

from the mains. Use four screws and washers when mounting the amplifier to the front rack

Dimensions - 11

rails. Rear support is also recommended, especially for mobile or touring use. To reduce the

Warranty - 12

risk of fire or electric shock, do not expose this apparatus to rain or moisture.

Requirements

SRA-Series amplifiers have specific physical, electrical and signal requirements for proper

operation. These requirements will vary depending on your specific application, setup, and

the settings on the amplifier. When setting up and testing your system, please take special

care to double check all connections and settings. Please refer to the specifications section

of this manual for specific input, output and other figures.

Installation Density

SRA-Series amplifiers produce substantial power output from a very small chassis. When

driven at the higher-end of their potential, they do produce heat that must be dissipated. In

cases where multiple SRA amplifiers are mounted together (or a single SRA with other

equipment), it is recommended that a 1RU space is left between units to allow for proper

air circulation. If the amplifier overheats, it will go into 'thermal' protect mode to prevent

damage to itself and any connected components and speakers.

Operator Manual – SRA Series Amplifiers

Rear panel:

High Pass Filter(s) = Off

Gain Selector = +26 dB

Mode Selector = Stereo