Cypress CA-USBHUT Operation Manual - Page 9

Browse online or download pdf Operation Manual for Receiver Cypress CA-USBHUT. Cypress CA-USBHUT 16 pages. Multi-functioning hdmi/usb/rs- 232 & ir over single cat5e/6 transmitter and receiver extender box
Also for Cypress CA-USBHUT: Operation Manual (11 pages)

Print Page

7.3 Receiver's Front Panel

LINK

①

②

① Link LED: The LED red will illuminate when the device has received output

display ' s single and input source ' s data.

② IR: receiver: This IR reciever can accept IR signal of the HDMI input source

device with frequency between 20~60Hz and can send the signal over

CAT5e/6 to transmitter side to control the input source equipment.

③ LINK PAIR SELECT: This dip switch allows user with matrix setting for link up

to 16 pairs of the devices with single IP router. Each pair must have

the same dip switch setting in order to pair to the right device setting. The

factory default setting is at 0000.

④ VIDEO MODE: Press this button to switch in between the video and

graphic mode. The OSD will display your selection every time when the

button is pressed.

For EDID update: Connect both transmitter and receiver box together

with CAT5e/6 cable and power on the transmitter side, then press this

button constantly before powering on the receiver side. The LINK LED

will light up instantly and go disappear, when the LED is light up again

with blinking this button may be released. Under multiple link of receivers

the EDID update will always be stored with the last update setting.

⑤ LINK button: Press this button once or twice to allow the receiver to be link

up or unlink with the transmitter and the OSD will show "Starting USB" or

"Stopping USB" on the HDMI output display.

Under multiple link of receivers on a single transmitter, press it for 3sec to

get the host control of USB on the receiver. When the LED illuminate it

means the device has obtain the USB authority.

⑥ USB 1~4: These slots are for users to connect with keyboard, mouse, HDD,

USB ﬂash drive and ... etc. for USB hub function and KVM usage.

LINK PAIR SEL

③

④

⑤

USB

CAT5e/6 to HDMI/USB/IR/RS232 Receiver

⑥