1010music Toolbox v1.1.5 Quick Start Manual

Browse online or download pdf Quick Start Manual for Recording Equipment 1010music Toolbox v1.1.5. 1010music Toolbox v1.1.5 2 pages.

Print Page

Before You Start

A microSD card must be inserted into toolbox

before you can get started. All presets are stored

on the microSD card. Preset changes are only

saved when you choose to save them.

Overview

Toolbox offers touchscreen control of sequencers,

function generators and CV controllers that provide

CV and MIDI outputs for use in controlling other

modules. Toolbox by itself does not generate any

sound.

The Main screen shows an array of cells that can each

contain a sequencer, function generator or CV

controller. The cells of the array are mapped to the

input and output jacks below the screen. The cells in

Column 1 (on the left) show the state of the CV

Modulation Inputs. Note that CV Mod In 4 also

controls playback.

You can configure each cell in columns 2 through 5 to contain one of the following:

Name

Description

GATE

A sequence of gate signals displayed in a grid of cells where the color of the cell

Sequencer

indicates whether the signal is on or off at that step in the sequence.

NOTE

A piano roll style sequence of notes displayed with the keyboard running down

Sequencer

the left side, and the sequence steps scrolling from left to right.

Low Frequency

A variable control voltage generated by a cycling mathematical function, such as

Oscillator (LFO)

a triangle wave, ranging from -5V to +5V.

CV Sequencer

A variable CV voltage generated by drawing a bar graph on the touch screen,

(SEQ)

with a range of 0 to +5V.

CV Recording

Record incoming CV signals from the CV1 and CV2 inputs. After the recording is

(CREC)

completed, automatically changes to a CPLY.

CV Playback

Plays back a control voltage signal that was recorded via CREC or from an

(CPLY)

imported WAV file.

CV Output

Use this with a CPLY cell to play back an additional channel from the WAV file

(OUT)

loaded in the CPLY cell, for a total of up to 8 channels.

Start Playback of the Sequencers and Function Generators

To control playback of the sequencers and function generators:

Press the HOME button to display the Main screen.

Touch Play in the lower left corner of the screen to toggle playback on and off.

Note:

Connect the outputs of Toolbox to a module that generates sound, such as Synthbox, to hear playback.

•

You can also use CV Mod In 4 to control playback. Each high signal received on CV Mod In 4 will toggle playback on and

•

off.

Work with Presets

A preset is a set of pre-configured sequences, function generators, CV controllers and modulators. You can use the 1010music presets

or create your own.

Select a preset from the Main screen by touching + and – at the top of the Touch Screen on either side of preset name.

•

To save changes to a preset, touch the preset name, Edit, then Save.

•

To create a new preset, touch the name of the preset on the main screen, and then touch New. Touch Edit and then

•

Rename to provide a name for the preset.

10/29/18 12:00 PM

Toolbox v1.1.5 Quick Start Guide

Ma in Screen