Dolphin 02.4011 User Manual - Page 3

Browse online or download pdf User Manual for Dryer Dolphin 02.4011. Dolphin 02.4011 8 pages. High speed hand dryer

Print Page

P RO D UC T DATA

Input

Motor

VAC

Inrush

A(W)

220

2.86 (630)

230

2.99 (689)

240

3.13 (750)

M E CH A N I CA L

I N STA L L ATI ON :

Recommended wall opening for proud mounting: 360w x

›

431h x 112d

Position the unit into the prepared wall recess allowing a

›

6mm clearance all around the unit for packing and

adjustment.

Open door panel of dryer using key provided.

›

Remove and retain 2 cover screws from underside of internal

›

dryer casing, remove casing.

Provide supply wire in accordance to local wiring regulations

›

to hole location in rear of back box and attach securely to

chassis with suitable cable gland (May differ to that supplied)

Fit temporary screws into slots on side walls. Do not fully

›

tighten screws into wall to allow for horizontal adjustment.

Fix casing to surrounding structure using suitable screws. Pack

›

and adjust as necessary to ensure unit is square and level. Do

not over tighten screws or the unit casing may become

distorted. Remove temporary screws from slots.

Re-fit internal dryer casing and re-fit retained screws.

›

Close and lock door

›

02.4011 User Manual

Heater

Operating

Inrush/

A(W)

Operating A(W)

1.91 (420)

2.00 (459)

2.08 (500)

Total

Inrush

Operating

A(W)

4.77 (1050)

3.82 (840)

4.99 (1148)

3.99 (918)

5.21 (1250)

4.17 (1000)

ELECTRI CAL

I NSTALLATI ON:

WA RN I N G

Disconnect power at the service breaker before installation

›

or servicing

A qualified electrician must install this product. It is

›

recommended that this unit be checked every 6 months

All units must be supplied with a 3-wire service. The earth

›

wire must be connected to the dryer's back plate

The means of disconnection must be in the fixed wiring in

›

accordance with the correct electrical regulations

DAN GE R

Failure to properly ground unit could result in severe

›

electrical shock and/or death.

Open door panel with suction cup provided.

›

Door is right hand hinged.

Remove and retain 2 cover screws from underside of internal

›

dryer casing, remove casing

Provide supply wire in accordance to local wiring regulations

›

through suitable cable gland (May differ to that supplied) in

rear and attach securely to chassis

The hand dryer must be supplied from the mains (220-240

›

volt supply) via a suitably rated double pole isolation switch

with at least 3mm air gap in each pole.

Connect supply and ground wires to terminal block where

›

indicated or connect supply wires to terminal block where

indicated and connect ground wire to base with ground

screw

Re-fit internal dryer casing and re-fit retained screws

›

(Do not overtighten)

Close door

›