Cypress Semiconductor CY8CKIT-002 User Manual - Page 12

Browse online or download pdf User Manual for Motherboard Cypress Semiconductor CY8CKIT-002. Cypress Semiconductor CY8CKIT-002 20 pages.

Print Page

Installing MiniProg3

2.3

MiniProg3 Installation

The MiniProg3 programmer and debugger are supported by PSoC Programmer, PSoC Designer,

and PSoC Creator. Secondary software, such as Bridge Control Panel and Clock Programmer, use

the programmer COM hardware layer to support MiniProg3 functionality.

1. Download and install

2. Connect the MiniProg3 to your computer's USB port using the USB cable. When properly

connected, the four LEDs on the MiniProg3 flicker.

The first two MiniProg3 drivers are automatically installed.

Note Remove the warning sticker before using MiniProg3.

3. Run PSoC Programmer: Select Start > All Programs > Cypress > PSoC Programmer.

The second MiniProg3 driver is automatically installed.

4. In PSoC Programmer, select View > Modern.

Figure 2-3. PSoC Programmer in Modern View Mode: MiniProg3 Selected and Connected

5. To connect to the port, in the port selection window, click the MiniProg3 device. You can also click

Connect/Disconnect.

If the connection is successful, the green status LEDs on MiniProg3 light up and a blue dot

appears next to MiniProg3 in the Port Selection box. Also, the indicator in the lower-right corner

of the PSoC Programmer window turns green and shows Connected.

You can now use MiniProg3 and the functions it supports.

For more information on how to use PSoC Programmer, see the

PSoC

Programmer. Follow the instructions to install the software.

CY8CKIT-002 MiniProg3 User Guide, Doc. # 001-59350 Rev. *E

PSoC Programmer User

Guide.