EG4 MPPT100-48HV User Manual - Page 2

Browse online or download pdf User Manual for Battery Charger EG4 MPPT100-48HV. EG4 MPPT100-48HV 10 pages. Mppt charger 100a 48vdc

Print Page

ABOUT THIS MANUAL

Purpose

This manual describes the assembly, installation, operation, and troubleshooting for this unit. Please

read this manual carefully before installation and operation.

Scope

This manual provides safety and installation guidelines as well as information on tools and wiring.

WARNING: This chapter contains important safety and operating instructions.

Read and keep this manual for future reference.

1. Before using the unit, read all instructions and cautionary markings on the unit, the batteries and all

appropriate sections of this manual.

2. CAUTION - To reduce the risk of injury, charge only deep-cycle, lead acid, or Li-Ion type

rechargeable batteries. Other types of batteries may burst, causing personal injury and damage.

3. Do not disassemble the unit. When service or repair is required, take it to a qualified service center.

Incorrect re-assembly may result in a risk of electric shock or fire.

4. To reduce the risk of electric shock, disconnect all wirings before attempting any maintenance or

cleaning. Turning off the unit will not reduce this risk.

5. CAUTION - Only qualified persons should install this device.

6. NEVER charge a frozen battery.

7. For optimum operation of this MPPT charger, please follow the required specs to select the

appropriate cable size.

8. Be very cautious when working with metal tools on or around batteries. A potential risk exists for a

dropped tool to spark or short circuit batteries or other electrical parts causing a fire.

9. Strictly follow installation procedures when connecting DC terminals. Please refer to the installation

section of this manual for details.

10. Breaker is required as over-current protection for the battery supply.

11. GROUNDING INSTRUCTIONS - This charger should be connected to a permanent grounded wiring

system. Be sure to comply with local requirements and regulations when installing this charger.

12. NEVER short DC inputs.

13. Warning!! Only qualified professionals are permitted to service this device. If errors persist

after following the troubleshooting table, please contact the tech department of the distributor where

you purchased your product.

DISCLAIMER

EG4 reserves the right to make changes to the material herein at any time without notice. You may refer

to the EG4 website at www.eg4electronics.com for the most updated version of our manual.