Askari Scout Operator's Manual - Page 2
Browse online or download pdf Operator's Manual for Security Sensors Askari Scout. Askari Scout 2 pages. Outdoor dual pir motion detector
Print PageThe Askari Scout is a Wireless, Dual PIR Motion Detector
with Bi-Directional Communications
Transmits intruder signal to the Askari Alarm I/O and the
•
Askari Nano
•
Transmits Autotest and Tamper signals to the Askari Alarm I/O and Nano
•
Has an open-field transmitter/receiver range of 400 meters
Receives confirmation of transmissions from the Askari Alarm I/O and Nano
•
Receives configuration update data from the Askari Nano
•
Programming
The Askari Scout can be programmed into the Askari Alarm I/O or the Askari Nano
Remove the battery cover from the Askari Scout using the Allen Key supplied
(in the Alarm I/O package)
Remove the battery-saver tag.
The Scout will start up, hit Tamper SW to 'Walk-Test' mode. The on-board buzzer will
activate and will beep once for a bottom eye trigger, twice for a top eye trigger and 3
times for both
The Scout will settle after 1 minute
Programming into an Alarm I/O
•
To enter programming mode on the Alarm I/O, press and release the Program
switch on the Alarm I/O
•
The Program/Delete LED will switch on and the LED's of all programmed zones
will switch on
•
Wait a few seconds, the Program/Delete LED will switch o and then on again,
and all the programmed zone LED's will switch o
•
You are now in Programming mode
•
Press and release the appropriate zone switch on the Alarm I/O, the zone
LED will switch on
•
Trigger the Scout Tamper code by pushing the Tamper switch
•
The Alarm I/O will accept the programming, return to standby mode, and
all programmed zone LED's will be on
•
Replace the battery cover
•
Repeat as above for all other Scouts, programming them to individual zones
Transmitter
Receiver
NOTE: A) The on-board walk-test buzzer will continue to be active until the Scout
has had no intruder triggers for 20 minutes
B) When the Scout is programmed into a Alarm I/O, and in walk-test
mode, intruder signal (3 beeps) will be followed by a low tone to con rm
RF communication. This allows the installer to position the Scout
anywhere on the property where RF communication is confirmed.
Programming into a Nano
To enter into programming mode on the Nano, press and hold button 1, now press
button 8 and release both buttons.
The LED's for buttons 1, 4, 5, 6, 7 and 8 will light up.
Now press the right hand side button to activate programming mode - the Nano will
emit a high tone to con rm you are now in programming mode.
Press button 1 for detector programming – the Nano will beep once to con rm you
are in detector programming mode
•
The Nano zone LED's will switch on for any programmed zone.
•
Select the appropriate zone on the Nano, the Zone LED will switch on and all
other zone LED's will switch o
•
Trigger the Scout Tamper code by waving your hand in front of it with
the battery cover o
•
You will hear a beep and all lights will flash to signal the programming is
complete and the Nano will return to standby mode
•
Repeat as above for all other Scouts, programming them to individual zones
Product Operation
Mounting height
0.8 to 1.2 m
Side view
Top view
Parallel
15 m